Software
Houzz Logo Print
try_hard

Where is the granite FAQ?

18 years ago

Maybe I'm dreaming this, but I thought there was a Granite FAQ on this board. I'm trying to find granite cleaning instructions - what to use, what not to use, etc.

Can anyone point me in the direction of the FAQ?

Thanks!

try_hard

Comments (10)

  • 18 years ago
    last modified: 11 years ago

    bump

  • 18 years ago
    last modified: 11 years ago

    As far as I know there's no FAQ concerning the care and cleaning of granite. There have been numerous threads discussing stone cleaners though. You might want to do a search or, if you cannot find anything, start a new thread.

  • 18 years ago
    last modified: 11 years ago

    Thanks Buehl! I'll do that.

    try_hard

  • 18 years ago
    last modified: 11 years ago

    Apparently my searching abilities are feeble, because I can't find the GW post I just used to help me 2 weeks ago. I saved it to a word document so I am going to cut and paste it into here (HTH):

    RE: granite template being done today - many questions...
    Posted by franki1962 (My Page) on
    Wed, Feb 6, 08 at 11:49
    Stolen from a previous post
    I think it dropped off this past week or so...the last post to it was 10/31. I have it saved. Here's a summary of it:

    When deciding on a fabricator:
    - See the installer's work, especially the seams;
    - Talk about what they do to make the seam really tight and smooth.
    Before Fabrication
    - Mock up the location of the faucets, soap dispenser, air switch, air gap, etc. before they come to fabricate. Be sure to account for clearances behind the sink as well as b/w each item.
    -- Make sure you have your sink/faucet templates (all sinks & faucets!)
    -- Make a list of all your appliances and the required clearances (sides, back, front, top). This applies to both appliances w/cutouts (e.g., cooktop, etc.) and stand alone (e.g., refrigerator, range, etc.).
    - Make sure you have enough of your lighting installed and functional
    - Make sure you have everything that requires a cutout before they fabricate. You want to have all of these on hand when they come for templating.
    - Post pictures for the TKOÂed of your slabs!
    Fabrication/Pre-Install
    - Be present for the template process.
    - Be there when they place the templates on your slabs, but if you can't be there then have a lengthy conversation about seam placement, ways to match the movement, and ways to color-match the counters that will be joined at the seam
    - Double check the template.
    - Make sure that the measurements are reasonable.
    - Measure the opening for the range.
    - Be sure you test your faucet for clearances not just between each fixture, but also between the faucet and the wall behind the faucet (if there is one). You need to be sure the handle will function properly.
    - Make sure the cabinets are totally level (not out by more than 1/8") before the counter installers come in. Saves big headaches.
    - Make sure they have the sink/faucet templates to work from.
    - Check how close they should come to a stove
    - Make sure you have your garbage disposal air switch on hand or know the diameter
    Installation
    - If you have wood floors--especially if you're in the process of staining or finishing them--make sure they don't spill or drip granite sealer on the wood floors. Apparently the sealer interferes with the stain or finish process. Possibly consider brown kraft paper to protect your floors.
    - Make sure your appliances are protected during the installation process.
    - Make sure you have a pretty good idea of your faucet layout--where you want the holes drilled for all the fixtures and do a test mock up to make sure you have accounted for sufficient clearances between each fixture.
    - Somewhere you will have a seam by your sink because they cannot carry the small pieces after cutting out for you sink without breaking. Ask them to show you where it will be and if you are ok with it. Should be covered in the appropriately colored caulk.
    - Check the seams for evenness and smoothness.
    - Make sure the seams are neat and clean.
    - Make sure the seams are not obvious.
    - Make sure there are no scratches, pits or cracks
    - Make sure the granite has been sealed
    - Ask which sealer has been used on the granite.
    - Make sure the sink reveal is consistent all the away around
    - Check the gap of the granite at the wall junctions.
    - Keep an eye out for inconsistent overhangs on the counter edges
    - Make sure all your edges are identical
    - Make sure the laminate edge (if you have it) is smooth.
    - Check for chips. These can be filled.
    - Make sure the seams are butted tight.
    - If a cut-out or a seam is worked on OVER a drawer, be sure to remove the drawer and tape the glide. There have been instances where the granite dust destroyed the drawer glide.
    - Make sure that the top drawers open and close
    - Make sure the stove sits up higher than the counter
    - Make sure you can open your dishwasher
    - Make sure you have proper clearances for all of your appliances.
    - Make sure you have the appropriate clearances for your appliances.
    - Make sure all your cabinets are still in the right place.
    - Watch when they apply the sealer, so that you know how to do it later.
    Post Installation
    - Post pictures for the TKOÂed
    - Enjoy your kitchen!

  • 18 years ago
    last modified: 11 years ago

    Whoops, just read your question more closely - you wanted cleaning instructions - Sorry!

  • 18 years ago
    last modified: 11 years ago

    Now granite countertops come with a new treatment called PermaShield, which is better than a granite sealer.

  • 18 years ago
    last modified: 11 years ago

    Bump... before we lose it.

  • 18 years ago
    last modified: 11 years ago

    Are you perhaps looking for this?:

  • 18 years ago
    last modified: 11 years ago

    Or this? This is a compilation of StoneGirl's thread that others have saved and reposted and other threads from other stone experts (Kevin, Joshua, Mimi, etc.). (Mostly from StoneGirl, though)

  • 18 years ago
    last modified: 11 years ago

    Thanks everyone! Sorry I'm so slow to respond.

    try_hard

Sponsored
Mary Shipley Interiors
Average rating: 4.8 out of 5 stars34 Reviews
Columbus OH Premier Interior Designer 10x Best of Houzz