Software
Houzz Logo Print
per08

undermount sink and silestone countertop

18 years ago

Anybody has an undermount sink with silestone countertop? How is the undermount sink installer? Recently I installed the silestone coutertop with undermount sink from HD. And the sink leaks.

As the silestone is pretty thick, it doesn't require plywood underneath. The installer put plywood at the sink cabinet (which is supported by the sink cabinet sidewall), and then cut the hole and drop in the sink. However, this kind of supporting is not strong enough, and the sink leaks. Now we had to remove the countertop, and re-install again.

I searched the internet, and found that there are two ways to install the sink. 1). There is plywood everywhere under the counterop, everywhere, not just in the sink cabinet. Then cut the plywood and drop in the sink. 2). Use clips. Drip holes in the countertop, and use clips to attach the sink to the countertop.

I believe the above two methods are all OK. In my case, there is only a ring of plywood left after the cut, obviously, there is no enough support for the sink.

Due the leakage, both the supporting plywood and the sink cabinet got mold built up. I think I have to replace the cabinet.

I prefer to use clips to hold the sink instead of the plywood. But the installer says the clips are for small sinks such as in bathroom; for large sinks plywood is better. So next time they will still use plywood. I don't believe in them. Anybody has any experience to share?

Comment (1)