Software
Houzz Logo Print
mikeylee1

find which wire is from box to ceiling light

19 years ago

I need to find which wire is coming from the box to either one or the other switch or hall ceiling light fixture. this is a three way light and it does not work. I have checked the wires at the each switch and the wire on one switch is three wire switch with three wire but the other switch is only two wire switch with two wire. This house is 36 years old. we bought it a couple of years ago. switch has never worked.

Comments (4)

  • 19 years ago

    mikeylee1 you would do yourself a favor if you posted on the electrical wiring forum listed below. Most of these guys are good.

    http://ths.gardenweb.com/forums/wiring/

  • 19 years ago

    A 3 way circuit should have a 3 way switch at each end. A single pole switch with 2 wires will not work in a 3 way switch.

    See link below for 3 way switch diagrams

    Here is a link that might be useful: 3 way switches

  • 19 years ago

    If you look at a three way switch you will see three connections. On the lower right hand of the switch is a bronze screw. This accepts the black power line. There is a regular brass screw above the bronze and another screw on the other side of the switch. These both accept the travelers which is another black and a red. Both three way switches must be on the same 14/3 or 12/3 circuit and be wired exactly the same on both ends. As your switches are now wired it sounds like they are on seperate circuits.

  • 19 years ago

    You should first use a simple electrical tester to be sure there is no power to the fixture since replacing the fixture might also solve the problem. Do the same at the switches to rule out a problem at the service panel.

    In a conventional 3-way switch configuration the third wire (red) runs between the two switches even if it takes the long way through the fixture box. There are always 3 wires to each switch.

    If the master dimmer switch is an X-10 type that doesn't require a neutral, the auxiliary (slave) switch can be connected with 2 wires.

    This is a very complicated subject and virtually impossible to discuss online because there are so many ways this kind of circuit can be configured although there are probably people on the electrical forum that could make some pretty good guesses. I never rely on guesses.

    Save yourself a lot of trouble by hiring an electrician or if you have to do it yourself, turn off the power, label the wires carefully and take the old switches to an electrical supply house for replacement. Don't go to a big box store and don't imagine you are going to understand the circuit well enough to make substitutions on your own.