Software
Houzz Logo Print
sammy_gw

gutters

18 years ago

Our gutters are falling because the wood that they are attached to has begun to rot.

We need a new roof, and are waiting until next spring when we can better afford it -- and the cedar siding.

I don't know what the piece of wood that is holding the gutter is attached to. Do any of you have good ideas of how to hold the gutter up until we replace the roof? This seems like a silly question to me, but I am often surprised at the ideas that I would never have thought of.

Sammy

Comments (7)

  • 18 years ago

    How are they fastened now?

    For aluminum gutters I would use a spike and ferrule. That is a hollow tube that fits in the gutter and a loooong nail. Hold the tube in the gutter, drive the nail thru the outside, thru the tube, then the inside, then into a joist. This is quick and dirty and you don't have to remove the gutters.

  • 18 years ago

    Hendricus, thank you. I showed this to my husband, and he said that is what he is doing, but the piece of wood that he drives the nail into is rotting. He said he has repaired the gutters so many times, that the wood is splitting when he puts the nails through.

    Actually what he should say is that he has never cleaned out the gutters regularly, and has not been prompt in his repairing the gutters. Therefore far too many times when it rains, the water washes down over the wood that the nails attach to and has begun to rot it out.

    The day I emailed this, he went out and nailed the gutters more securely again. I just wondered if there was another option.

    I appreciate your reply.
    Sammy

  • 18 years ago

    There is also a strap that goes from the head of the nail or an attachment to the edge of the gutter and then slips and fastens under the shingles. Our last house had that and it could carry a lot of weight.

    We now have 30" overhangs and eliminated our gutters, no more cleaning and no more water in the basement.

  • 18 years ago

    A gutter should not be attached solely to the fascia board (which is the board that is rotting, if I have your description right). The nails/screws should go into the end of the rafters/joists that hold up the roof. Hopefully those have not rotted. If they have, I'd think about finding a way to accelerate the pace of your repairs.

  • 18 years ago

    I suppose there is no easy way to find a joist or rafter is there?

    Also while I am asking -- would you ask the same company to put on a roof, and put on new cedar siding? Three years ago we had a carpenter put on new cedar siding, and he just put on plywood (and painted the house.) It looked good to us at first before we realized that it was not the rough sawed cedar that the rest of the house was above the brick. Now that we are investing in a new roof, I also want to have the cedar replaced, and the house painted again. They spray painted, and the paint has not lasted.

    Are there some people who do everything? Or should we look for roofers, carpenters, and painters?

    Sammy

  • 18 years ago

    The facia board is attatched to the ends of the rafters with (surprise) nails. Look for the nail heads on the fascia, and you know where the framing lumber is.

    People who do everything are handymen. Companies who do everything are general contractors. Whether you're better off with one of those or with specialists depends on who's available in your area. Good luck.

  • 18 years ago

    What kind of siding? Shingles? If so, a roofer may well be able to do that. If it's clapboard or genuine siding you might want someone else.

    If you're having cedar siding, I would consider stain rather than paint. The reason cedar is valuable/expensive is because it's water resistant and thus rot resistant. Stain will protect it, be more attractive, and less expensive to maintain.