Software
Houzz Logo Print
spiffy6241

grasscloth - seam placement help

17 years ago

Well, I am FINALLY getting to install my grasscloth today. I am in a quandry about seam placement however, so any advice would be greatly appreciated.

The wall that you see when you enter the room is 66" wide.

The vanity is 39" and is sited in the left corner.

My grasscloth is 36" wide

The distance from the wall to the faucet is 20"

Here are the choices that I am considering:

#1 Use one full width piece in the left hand corner and use a piece cut to 30" for the remainder of the wall (this allows me to use two machine cut edges next to each other)

#2 Use three pieces, using the following widths 15", 36", 15" (More work, more chances to screw things up)

#3 Or use two pieces cut to 33" each, which would have a seam dead center on the wall.

Choice #1 would be easiest, but I am afraid that the room would look out of balance

Choice #2 is my preference, although I wonder expending the effort to cut/hang three pieces of paper when one seam will be covered by the vanity mirror.

Choice #3 would be a compromise, but I question the seam in the center of the room.

So what do you all think I should do?

Thanks so much!

Here is a photo of the vanity shown with one full width of the grasscloth:

Comments (10)

  • 17 years ago

    I'm not sure what you mean....
    If I were doing it I would start with the grasscloth in a corner, and lay the next strip next to that...cut edge to cut edge. Start with the 66 inch wall...lay 2 strips. Either take the extra 6 inches around the corner (which would be my choice) or cut in the corner and start the next piece in that corner.
    There should be no need to cut the paper lengthwise but for in a corner or against a door way.
    The only reason for not going around the corner would be if your room isn't plumb....did you drop a plumb line?
    Linda C

  • 17 years ago

    I would probably do the 36" /30" rather than trying to center the seams. Grass cloth is going to have visible seams obviously, and I wouldnt do anything that made a "pattern" out of it. I would probably start with the 6" strip around the corner. You are correct that it should be cut at the corners with grasscloth,IMO,it doesnt go around corners well.

  • 17 years ago

    I did grasscloth in my powder bath. It is 5 feet by 8 feet. I will take pictures and post tomorrow. Here is a picture, the others were too dark to post.

    My wallhanger put a color that matched the wallpaper where the seams joined, it helped lessen the seams obvious presence. I am not sure I like the finished look as I was envisioning something else. The seam you see in this picture is on the 5 foot wall and she made it at 30. I will get back to you on the longer wall. i hope this helps you.
    {{!gwi}}
    {{!gwi}}

  • 17 years ago

    Because the wall IS so small, I would do choice #2. I think the variations in the grasscloth could look off-balance in the other two choices.

    As a piece of advice, however...I don't know if you have instructions to do so, but many grasscloth instructions include the info to flip every other piece...in other words the first piece from the roll goes up the wall, the 2nd piece goes down the wall. This helps blend in any variations in shading from left to right on the roll.

    Helene

  • 16 years ago

    We professionals NEVER use a factory edge with any natural fiber wallcoverings. Each strip should be trimmed using a straightedge made for trimming wallcoverings. Your balancing choices are interesting. I would never consider #1.
    #2 is the "normal" way, but your off center sink does pose an issue. How would the far left strip of 20", then a middle strip of 26" and then the far right strip of 20" appeal to you? That way you would have a seam over the faucet and the oveall look would look balanced.

    Here is a link that might be useful: Eastern Mass Wallcovering by Bill Archibald

  • 16 years ago

    I agree....#2.

  • 16 years ago

    I forgot about this post! (I must have been traumatized by the installation, lol.) I will have to put up some pictures later. I actually did the third option. I was concerned about having two seams on such a short wall. Sometimes you have to go with what you have, and although the balance was a bit off, 90% of the seam was covered by the mirror and the vanity backsplash, so in the end it turned out to be much ado about nothing.

    But oh my, that was a tough installation! I am pleased with the results, but it took me seven hours straight. Squatting to cut the pieces, then up the step ladder to hang. My legs felt it for a couple of days! My fingertips were rough from smoothing the grasscloth out. I used a dry paint roller to do most of the smoothing, but I had to use my fingers to get the seams to be perfect. I didn't have any other major installation issues with the exception of the normal issues that come with hanging paper in rooms that are out of square and have oddly angled walls. I did a lot of dry fitting, and in the end, I think that it is the main reason that it looks good. I'm not sure that I will ever hang grasscloth again, and I am a pretty resilient do-it-yourselfer. Whatever you have to pay to have it professionally installed is well worth it!

  • 16 years ago

    Bill - I was wondering why you don't use the machined edges? I would have thought that those edges would give you the tightest seam. I'm curious about this, not that I will ever hang any grasscloth again!

  • 16 years ago

    oh goodness...spiffy6241, we have grasscloth in our future...(yikes)...!

    mmmm, i am now second guessing,...

    can you say you love your finished project?

    youngdeb, wow...how tranquil your room feels!