Software
Houzz Logo Print
wallycat

square cornered sinks (zero-clearance??)

14 years ago

Does anyone have those new modern square stainless sink?

Do you love it? Hate it? Wish you had not gotten it?

So few drop in stainless sinks now for the size we need in a single bowl...and 16 gauge.

Thoughts are appreciated.

I worry the corners are really hard to keep clean.

Comments (4)

  • 14 years ago

    Sorry, I think I meant zero-radius ...??

  • 14 years ago

    My kitchen sink is a Franke with rounded corners, but my master vanity sinks are Kohler rectangles--very modern square corners. Hate them. They look great but are PITA to keep clean as the corners trap lint, dusk and cleaning solutions.

    I neer considered that this shape would require index finger scrubbing. Yuck.

  • 14 years ago

    We love ours. Have had it for just over 5 years now. I honestly don't find mine to be difficult to clean, or keep clean, corners and all. I smoosh (technical term--LOL) the sponge into the corners when I'm cleaning the sink, that's about it on a daily to every few days basis. When I'm really "deep cleaning", I'll poke a cotton swab into the corners (along with the drain crevices). Not much (if anything) is on the cotton swab after jabbing it into the corners.

    We have moderately hard water, so there is sometimes (a small am't) of mineral deposit build-up close to the corners, near the bottom of the sink. When it becomes noticeable, I'll make an extra effort to remove it when I'm cleaning the sink. FWIW, I also have to remove mineral deposits from my my granite, if a water spill or ring is left overnight to dry, and I have to do the same to the bottoms (floors) of our fireclay/porcelain bathroom sinks on a daily basis.

    So in other words, I don't find our 0-radius sink corners to be difficult to clean/keep clean, nor is it a royal PITA job when I do clean them.

  • 14 years ago

    Thanks ladies.
    I did find older posts via google (hate this search engine).
    UGH....
    I am so scared to get the Silgranit so am looking at stainless but I want drop-in/overmount and 16 gauge and NOTHING I have searched for has this in a single bowl, 33" width....except the galaxytools site with the zero-radius ...
    If my DH can ruin/destroy, overuse, and need replacing an item...it will happen, so I am a bit leery of the Silgranit (and the CR issue did NOT help).
    thanks for letting me whine and thank you for your feedback.