Software
Houzz Logo Print
susyk_gw

Hood motors!!!

16 years ago

Does it really matter how much CFM a hood has? Is a 370 CFM good or should I get something with 600 CFM or more? Does it make a big difference? I do cook a lot. I need to purchase my hood this week. Please help me, I am very ignorant about this subject matter.

Comments (5)

  • 16 years ago

    Before you go any further, please check with your local building inspector as to any code restrictions. If you are in a northern climate, there is likely to be a maximum cfm allowed not requiring make up air. Anything over that amount of cfm may require make up air and it can be several thousand dollars if you require an active system. I am currently having trouble finding a hood that meets the code specs without requiring active make up air and that also will meet my requirements. There are many variables which need to be considered to determine how much cfm you need. How long will your ductwork be, will there be elbows, how high will your hood be placed above your cooktop. There are quite a few links on this site with info if you do a search. I met with a HVAC installer to determine how many cfms I could install without requiring active makeup air and it varies depending on the hood you may choose, the other venting and fuel burning appliances, the square footage and so on. The concern about makeup air comes from the danger of having negative pressure. If the cooktop pulls out too much air, you could develop negative pressure causing your furnace,water heater or fireplace to back draft dangerous gases into your home. So even though it may seem like a simple thing to pick a hood, it is worth your time to do a little investigating. Good luck, I am still undecided about my situation.

  • 16 years ago

    High output hoods are not necessary in a lot of situations. The humongo hood phenomenon is overkill for many kitchens. I've been interested to note how many posters have no hood and no intention of getting one. They open a window.

    Many microwave hoods are minimally useful as a ventilator; compared to them, many other hoods are significantly better even if below 600cfm. Air flow is not the whole story when dealing with exhausted material.

    There are reviews in the Consumer Reports "Kitchen Planning & Buying guide" published last month.

  • 16 years ago

    There are many useful threads about this in the Appliances Forum. There is one poster named kaseki who has posted very helpful little discourses about the interplay among CFM, capture area, height of the hood. All these factors play into the effectiveness of the hood and should be considered along with the CFM of the motor.

  • 16 years ago

    To answer your question...in general, if you ...

    (1) have only one or two turns in your run to the outside
    (2) have the correct duct size (at least 8")
    (3) install it properly (usually no more than 30" off the cooking surface)
    (4) don't do a lot of frying or stir-frying and don't grill indoors
    (5) are installing against a wall (i.e., not an island or peninsula)

    ...then a vent around 600cfm is usually sufficient.

    However, if you...

    (1) grill indoors or do a lot of frying or stir-frying
    (2) have more than two turns
    (3) have a long duct run
    (4) are installing over an island or peninsula
    (5) want to install it higher than 30" off the cooking surface

    ...than higher cfms are needed.

    Additionally, if you get a hood w/higher cfms, then you can run it on a lower speed and it will be quieter.

    Note: Do not go with a duct less than 8" in diameter or a rectangular duct less than 50 sq inches. Smaller size ducting will not only be less effective, but louder.


    As to just opening a window instead...that will not properly vent, no matter what anyone tells you. To have a window be effective, you need all of the following all the time...
    First, you need a cross breeze that's going in the right direction;
    Second, your range/cooktop would need to be in front of the window so you're not sending the grease/smoke/etc. across the room first (defeats the purpose if it has to cross the room!);
    Third, you will need to be able to have the weather appropriate for year-round window opening...neither too hot nor too cold; and
    Fourth, you need to have a constant, fairly strong breeze to produce the airflow.


    For those that say you don't need a hood, I wish I could take you to my parents' home where there is a gunky build-up of grease/dust/smoke on the ceiling, walls, and surrounding cabinetry...they've never had a hood...and it shows despite periodic cleaning/wiping down!

    Here is a link that might be useful: Appliances Forum FAQ: Overview of vent hoods

  • 16 years ago

    Buehl's summary is excellent. From what I have READ... I would not go under 600 CFM, which is not considered high output.

    Also, I would pay close attention to the specs on noise -- whether expressed in dB or sones. The scale is not in equal intervals (like the thermometer), so 1 more sone or 2 more decibels makes a difference.