Software
Houzz Logo Print
gawlt

? Width of curtain panel between windows

14 years ago

I am planning on stationary, non-moving, french pleated or parisian pleated panels between each of the windows and at the ends (total of five panels.) I'm struggling with what the width of the panels should be.

The largest space is 18" from inside molding of one window to the inside window of the next molding. I figure the panels should extend past the interior edge of the wood molding.

I was told by a designer that one width of designer fabric (54") should be enough for each panel. I've read about how these panels are made along with the standard measurements. Essentially one fabric width usually gets you 5 pleats and is about 20" - 24" wide. I've mocked up a panel and when I put it up between the windows, it is basically opened flat.

So I'm thinking I need 2 widths of fabric to have the pleats butt up against one another and to have fullness.

Thoughts on panel width for between the windows: single width of fabric, double width, triple width? And if I double the panel width should I make the panel on the left near the tv doublewidth or single width? You can't see it in the picture but there is two feet of wall on the right side of this wall of windows. Want a balanced look.

Comments (23)

  • 14 years ago

    I planned to side with the designer and tell you one width should be fine...but then I saw your mockup. If you were doing clip ring panels or rod pocket, I think the 54" would be enough, but the pleated does look skimpy.
    Lovely windows you have...

    Red

  • 14 years ago

    Not a fan of that width or even of the pinch pleats for that area....

  • 14 years ago

    A 54 inch width of fabric....minus 2 inches for side hems...leaves 52 inches. You want a finished width of 20 inches....so that leaves 32 inches for fullness inside the pleats. You want 5 pleats....so that makes each pleat 6 1/3 inches of fullness....not a luxurious amount.
    Another 10 to 12 inches in each panel would be wonderful.
    So buy an extra length (or 2) of fabric and split it and seam it, doing the math so the seam is inside a pleat.....which may mean that rather than using a 54 inch wide length and 10 inch strip...to get the needed 64 or 65 inch wide panels you may need to split the 54 inch panels length wise into 2 panels.
    But...if you are planning on tying the panels....I think they need to be wider than 20 inches finished.....and I would like to see a longer unpleated strip on each end...if you are making them yourself.
    It's all just arithmetic..it's a pain to figure....but once it's drawn out...it's easy from there on in.....and will look a lot better than just pleating a panel!
    Linda C

  • 14 years ago

    Lindac: When you say "like to see a longer unpleated strip on each end", do you mean including "a return" which I understand is usually 3.5" and is folded in such a way that it is perpendicular to the wall (as opposed to flat how I show it)?

    LuAnn any alternative suggestions for the space?

  • 14 years ago

    I did something similar. We used 1 1/2 widths for most of the sides, but 2 widths for the center panel (between 2 windows).

  • 14 years ago

    Very nice, WhiteRiver~ !!

    Red

  • 14 years ago

    Thanks so much to all. Looks like it will be 1.5 to 2 widths. Think I'll mock up another one at those widths.

  • 14 years ago

    But, but, but...your windows are beautiful, and your view is spectacular, and you won't be closing the drapes. Do you want to "finish" the windows? What about the upper windows? Why do you have the mockup tied?

    I personally love fussy window treatments, but half of my house faces the woods, so we have bare windows, like yours, there.

    If you go with the panels, I agree they need to be full.

  • 14 years ago

    Have you thought about using grommet panels? My SIS has windows like yours and used grommet panels on the bottom windows only. They stack nicely. Looks great. Sorry, no pics.

  • 14 years ago

    @sherrmann Here is a picture of the full set of windows.

    The bottom windows have cream Hunter Douglas Silhouettes. The middle and top set of windows are left uncovered so that the eyes do not drift up (24' ceilings) and instead stay in the 9' and down area. The home is in the mountains and currently going for a "transitional style" ... not too formal, modern, traditional or rustic. Thought a valance across the whole length would make the room too formal.

    I tied the mockup because the center doors open and close right where the panel hangs and people go in and out in the summer. However the panels can easily hang without.

    Other thoughts?

    @door1 - had considered grommet panels but thought too casual for the fabric which is a transitional silk.

  • 14 years ago

    We also had the trim painted the same as the wall color as we found it featured the outdoor scenery rather than the eye stopping at the trim. The trim was narrow (nothing spectacular)so we went for it! I tried this for you......

  • 14 years ago

    I'm rethinking @door1's idea of grommet panels. It would allow me to use one width of fabric per panel instead of two and avoid the tricky challenge of color matching with this silk as the 1.5 yard sample I got has lots of color variation that would be impossible to match when two panels sewn together.

    Do you think grommet panels are too casual with silk fabric?

  • 14 years ago

    Another option besides grommet panels are back tabs. I think that they have a more elegant look than grommets and create a nice fold when hung.

  • 14 years ago

    You don't have a lot of wall space between the windows. I think 54" panels will be full enough. Remember each panel will be on each side of the window.

    I am basing my opinion on our stationary panels which were made with 7 pleats and are full. Ours flank each end of a 72' window. The pleats give drapes their fullness.

  • 14 years ago

    Sallymo makes a very good point about the silk. I have lined cranberry red silk shantung on my north-facing bedroom windows. After only 4 years or so, the leading edge is already beginning to shred, and has faded greatly. I am sad :>(

  • 14 years ago

    ....that I gasped when I saw the full picture of those beautiful windows. Wow!

  • 14 years ago

    Whan I say the space at the ends of the pleats should be longer....wider. I don't mean as in a "return"....that doesn't "return" to the wall...
    I just think ( and so do many drapery designers) it looks better to have a "frame" for the pleats.....a wider area of plain fabric at the outside edges.
    BUT...I am with sherrmen......why in heaven's name do you want to put fabric up on those fabulous windows? With the fabulous view? And no "apartment" across the way?
    Leave them alone!!!

  • 14 years ago

    Beautiful windows,.
    I also would like to see them left as is except for a panel on each of the ends.
    Hung on a short rod.

  • 14 years ago

    Thanks, Red.

    gawl - I have to agree that your windows are great and really don't need a thing on them.

  • 14 years ago

    I would certainly save a pretty penny if I skipped the panels :) However, at night and most days in the winter when the blinds are closed to keep some warmth in, the room and that wall needs a pick me up of color. (See pic below.) But I agree with all of you that I want to cover the windows as minimally as possible and just have a panel that fills the space of white wall board between the windows and at the ends. They will never close, just be stationary. Here's an updated picture of the room with current furniture. Need a coffee, end and sofa table and something for the wall on the right. The final panels would go to the floor not 3/4 as in the picture. The sample fabric I bought is not long enough.

    I'm liking @terriks idea of back tab panels as well.

  • 14 years ago

    I agree that that the room could use some color, but I wonder how much heat you are actually keeping in the room by closing the blinds, since you still have so much exposed glass. Also, cold air sinks and heat rises, so you have a tricky situation there with your cathedral ceilings.

    Have you considered using live plants to add color and interest? They would thrive in your conditions, as they do in mine. (I don't have your high windows, though, just 9' ceilings, French doors and windows.) You
    could hang some, set some on plant stands, and have a tree or two
    there. You have the makings of a beautiful arboretum!

  • 14 years ago

    I agree.....a couple of plants...or more.
    Don't mess up the lovely clean lines with drapery panels. Spend the money instead on an "important" piece of art for that blank wall opposite the fireplace. Don't put useless strips of fabric op with all the attendant rods and dusting etc etc. If you need something, do a painting on the wall...or a sculpture.