Software
Houzz Logo Print
theresse_gw

Microhood: Need one narrower than 29'!

16 years ago

I was about to go the range hood route since I can't find a microwave hood that's narrower than the standard - but I thought I'd ask one last time before giving up!

It appears all microwaves meant to hang above the stove and that have lights and a fan, are around 30" wide. The problem is that my antique upper cabs are 30" wide and that's too narrow for these microwaves cause the upper cab needs to hang down on along the sides of the microwave to give it the built-in look and hide the ugly sides of the microwave.

I require a fan and light, FYI, with the microwave. If you've EVER heard of a narrower above-range microwave/microhood, please do share!!!!!

Thanks so much. :)

Comments (2)

  • 16 years ago

    Ikea has a microwave+recirculating OR venting fan at $149. not sure if it's white or SS.
    http://www.ikea.com/us/en/catalog/products/90152027

    They also have at least one standard hood that's narrow. It's modern stainless steel and probably needs a vent. Other products are just a hair under 30 inches wide.

    I'm also responding to your previous vented vs unvented hoods post here...Are these the old style inset door cupboards? With a regular board running vertically on the outside of the hinges? Is there a door hinge on the range side of the cupboard? If so....Have you considered cutting out a half inch or an inch of the face created by that board, shortening the width of the cabinets on each side where the hood rides? If you lose the entire side wall at this spot, perhaps you could sub in something else like a piece of metal to serve for a side wall at that section that overlaps the side the hood? Or just let the side of the hood be the inside wall of the cabs in that spot?

    I'm looking at my white Broan Allure III (less than $400 last winter) as I type. There are 12 inches of space between the bottom of my cupboards and the top of the wide part of the range hood, in the distance from the range that we chose (If I recall, the mfg'er recommends 27 to 30 inches of space between hood and range top, and I think we split the difference. The depth of the cutout you'd need to make each side of the hood would vary with how high or low you mount the hood over the range. This model of hood can be installed as recirculating or outside venting, I think, so it might fit your "someday we'll be changing the vent" requirement, if you could grab a piece of the cabs at the bottom. The sides of our unit are white all the way to the back.

    Years ago, we had old cabinets over refrig. that didn't allow sufficient clearance for ht of newer refrigerators. We just ended up cutting into the molding at the bottom of the cabs and never looked back. There was a staple-shaped cut into the bottom of the cabs (but it didn't interfere with the lowest shelf on the cab, although it approached it). This was as good as solution as we could afford.

    One of the Broan Elite models got really high marks by Consumer Reports. I may be remembering wrong, but I think this model is the pull-out-when-in-use hood, probably in stainless, but has a minimal presence in the room when pushed in. I don't know if this is a hybrid style that can be vented or not vented. Such a unit might be more like a customizable thing if you can work it into an inset cabinet area.

    Some of the new hoods have new kinds of filters for unvented installations, which might make them more useful.

  • 16 years ago

    A little too small, but HTH :)

    Here is a link that might be useful: this might be TOO small but...