Software
Houzz Logo Print
cbchhaya

Running wires through ceiling

11 years ago
Hello

Our new hone has recessed lighting. It has an open floor plan too, which renders placement of surround sound speakers challenging. I am wondering if there is a way to run wires to a ceiling mounted pair of speakers without having to tear down or significantly damage the ceiling. along the same lines, how would I ever repair wires for the recessed lights? I am hoping that there have to be ways to do that without involving patch work and painting the ceiling every time.

Thanks.

Comments (6)

  • 11 years ago
    last modified: 11 years ago

    make sure you check out sonos. my very critical husband is satisfied with their system through out first floor, and has his old magnepan speakers in the upstairs den with the tv for more intense listening.

  • 11 years ago

    is the first floor system wireless? I am already invested in a denon but with the move to the new house, am wondering how best to place speakers in an open floor layout.

  • 11 years ago

    Why would you need to repair wires for the recessed lights? Those wires don't need repaired any more than any other wiring run through the walls of the house. Is there a floor above that ceiling or an attic? What kind of floor trusses are used?

  • 11 years ago

    Fred, I am not saying I need to repair them. I am trying to figure out how such ceilings work in general. How do electricians get wires in there? I was trying to understand how easy or difficult it would be to run another couple for my speakers - and hoping that it would not amount to something drastic, such as upending floors above or tearing the ceilings.

  • 11 years ago

    yes the sonos is completely wireless.

  • 11 years ago

    Most recessed are put in before drywall, where a standard housing is used. That is the easy way ;).

    To install recessed in an existing ceiling, a remodel can is used. Whether this is possible depends on the type of floor joists or floor trusses used. If the joists are standard 2×12 lumber, you can still fish wires in the same direction as the joists run, but it is harder to go perpendicular. If there are only two joists between each recessed can, you drill a hole through the joist from the hole in the drywall for the can. One joist from each direction, and make sure to line the drill up from center of light hole to center of other light hole when drilling. Then it just takes a steady hand with a good sense of touch to thread the wire through the holes. There are some special tools for the more daring, but that is usually as far as you can go and still know if you will be drilling through any other live wires.

    Take a bulb and trim out of one of the fixtures and post a picture here so I can see if it is a remodel can or not, and what size it is. If it is a 5" or 6" recessed, it is fairly easy to take them out or take the insides out to get into the ceiling and pull some wire. Then the only problem is getting the wires down the wall. That usually depends on more specific circumstances.

    Hopefully, that is along the lines of what you are trying yo figure out.