Hi.

These are all individual boards you place on the wall how you would like them. Usually put on the ground first to get your layout and colors right.

HINTS FOR INSTALLING FROM MIKE ;

I usually use Lepages PL Premium adhesive in a tube and apply a wave pattern of glue on the back of each piece. A 1/4” bead is a good amount and then place against wall , firmly pushing and a little twist to level out the bead. Every other row, I will nail through the edge into the wood studs for added support with a finish nail. For an easier job you can use the new Fast grab PL premium. Its a little more money but it sticks quicker. If you don't want to nail it, consider using some hot glue to hold each in place while the adhesive hardens and so the board doesn't move on you....or just hold longer.

IMPORTANT REMINDER. PL Premium is NOT water clean up. It requires mineral spirits to wash off, so try not to be messy with it.

If you go to this link of the product you should be able to see more description. [https://www.houzz.com/products/reclaimed-wood-wall-covering-diy-barn-board-mixed-sizes-prvw-vr~28456315?lid=15014989[(https://www.houzz.com/products/reclaimed-wood-wall-covering-diy-barn-board-mixed-sizes-prvw-vr~28456315?lid=15014989)