Software
Houzz Logo Print
shooting4john

Riding Mower Not Turning over

11 years ago

Craftsman 2011 LT 2000

19.5 hp Briggs with oil filtration


I Stopped mowing today. Went to refire it and it would only click. No jumper cables so I bought a new battery since the existing one was 2011. Nothing. Only a click (solenoid) and maybe 1.5 revolutions. As if the starter didn't have enough a$$. Hooked up my new jumper cables to the starter direct from my jeep. Same result. I can spin the magneto by hand no problem. Nothing bent or bound underneath and all disengaged. Picked up a new starter and same thing. Even though they tested my old starter and said it was fine but all signs pointed to a weak starter. Removed the spark plug and it turns over quickly. Put it back in place and click and a revolution or two at most. Removed intake and muffler and tried to crank it. Nothing. Reinstalled everything and at a loss. With a jumper cable going direct to the starters hot lug, it should turn over no matter of any safety issue you'd think. The shaft and mag turns by hand so I know nothing is bent or bound. Puzzled. One thing I did notice is when turning the key, my volt meter drops from 12.5 to 5.5 at the starters lug. This is what prompted me to jump 12V right to it to bypass the solenoid and wires coming up from the rear. The motor will not turn over by starter but spins fine by hand. Could it be a ground issue? Or time for a Honda powered machine......

Comment (1)

Sponsored