Software
Houzz Logo Print
joseph_corlett

Coved Richlite

11 years ago
last modified: 11 years ago

Here's a 1 1/4" x 48" x 96" slab of Richlite on a pallat. The blue line is a piece of 1/2" OSB; we removed another sheet of OSB and protective plastic to take the picture. Lots of wood and travel goes into this eco-friendly material. Picture a stack of 20 Sunday newspapers glued and pressed into a sheet; here you are.

The architect has specified a 3/4" cove which means a 1 1/2" router bit to create it. We've been told by other fabricators that Richlite can't be coved. Ha.

I like to get my screw-ups out of the way first thing in the morning. Apparently the Festool suction clamp doesn't play well with Richlite and let go as my router made its first pass. The fence and bit has drifted, cut too far in, and the edges of the cove are no longer parallel and therefore useless. Do-over.

The properly clamped fence with the cove "shoe" cut and about to be ripped by the Festool track saw. Even with a newly sharpened blade, I have to make two passes; this stuff is very dense. Nearly twice as dense as maple butcher block.

Ripped, cross cut, and rabbeted.

Coved shoe is adhered and clamped to the side splash ends and bottom.

The adhesive squeeze-out is abraded at the rabbet/shoe/splash joint.


This is the same joint with a 500 semigloss sample finish although this baker's top is getting a 180 and beeswax. There is no mistake at the cove; you're seeing Richlite on the flat on the deck and splash, but cross grain Richlite in the cove.

180 and beeswax.

Comments (8)

Sponsored
CHC & Family Developments
Average rating: 5 out of 5 stars6 Reviews
Industry Leading General Contractors in Franklin County, Ohio