Software
Houzz Logo Print
nelle77

Gardening Over Foundry Sand??

11 years ago

We recently bought a farm in WI it has a great flat site with water where a Ag hoop building used to sit(the building was sold and taken away back in 2002). We were planning on planting blueberries, raspberries and strawberries on this spot until we discovered that the fill they used under the previous building was foundry sand. On top of the sand they put the required amount of topsoil 12" I think. Right now we have hay growing on it for our cows.

I called the foundry where this sand was from and they refused to tell me anything.

So the question is: Would you plant a garden over foundry sand? I've had two people tell me different things about it and now I'm confused.

Thanks!

Comments (4)

  • 11 years ago
    last modified: 11 years ago

    From the EPA at http://epa.gov/osw/conserve/imr/foundry/index.htm:

    Based on the results of the risk assessment, the EPA and the USDA
    support the beneficial use of these materials that would otherwise go to
    waste, because the constituent concentrations found in silica-based
    spent foundry sands from iron steel and aluminum foundries are below the
    agency’s health and environmental benchmarks.

  • 11 years ago

    There is nothing wrong with using recycled foundry sand in a garden. Depending on the casting method, it may contain somewhat higher levels of ferrous materials (iron) but nothing particularly harmful.

  • 11 years ago

    Spent foundry sand once was used as "topsoil" mostly because it was black and "topsoil" is black. Spent foundry sand has several problems, all related to sand in general. It does not hold nutrients and moisture at all well, they flow out really rapidly.

    The only advantage sand has is that plant roots can move around pretty freely, and they have to in search of both nutrients and moisture. Sand needs a lot of organic material added to it so the moisture and nutrients plants need to grow are held in the root zone.

    Keep in mind that all of those require a soil that holds moisture quite well and the soil pH for each one is different, Blueberries require a fairly acidic (4.5 to 5.5) soil while Strawberries need soil a bit closer to neutral (5.8 to 6.2) and Raspberries much prefer a more neutral (6.0 to 6.5) soil. Good hefty amounts of organic matter may be needed to help hold the necessary moisture in that soil. So in addition to a good reliable soil test, your University of Wisconsin does that,

    http://uwlab.soils.wisc.edu/

    perhaps these simple soil test may be of some help.

    1) Soil test for organic
    material. From that soil sample put enough of the rest to make a 4 inch level in
    a clear 1 quart jar, with a tight fitting lid. Fill that jar with water and
    replace the lid, tightly. Shake the jar vigorously and then let it stand for 24
    hours. Your soil will settle out according to soil particle size and weight.
    For example, a good loam will have about 1-3/4 inch (about 45%) of sand on the
    bottom. about 1 inch (about 25%) of silt next, about 1 inch (25%) of clay above
    that, and about 1/4 inch (about 5%) of organic matter on the top.

    2) Drainage. Dig a hole
    1 foot square and 1 foot deep and fill that with water. After that water drains
    away refill the hole with more water and time how long it takes that to drain
    away. Anything less than 2 hours and your soil drains’ too quickly and needs
    more organic matter to slow that drainage down. Anything over 6 hours and the
    soil drains too slowly and needs lots of organic matter to speed it up.

    3) Tilth. Take a handful
    of your slightly damp soil and squeeze it tightly. When the pressure is
    released the soil should hold together in that clump, but when poked with a
    finger that clump should fall apart.

    4) Smell. What does your
    soil smell like? A pleasant, rich earthy odor? Putrid, offensive, repugnant
    odor? The more organic matter in your soil the more active the soil bacteria
    will be and the nicer your soil will smell, to a point. Too much organic matter
    can be bad as well.

    5) Life. How many
    earthworms per shovel full were there? 5 or more indicates a pretty healthy soil. Fewer than 5,
    according to the Natural Resources Conservation Service, indicates a soil that
    is not healthy.

    Many people will state that soil testing is not needed and that they have never had one done and their plants grow very well. However a good reliable soil test can save money by showing there is no need to spread some fertilizer, or that some might be needed and can help guide the gardener to the right soil pH for what is to be growing in that space, important to know since plant nutrients are more easily available if the soil pH is nearly where the plant likes it.

    kimmq is kimmsr

  • 11 years ago
    last modified: 11 years ago

    Iron and aluminum I wouldn't be concerned about. However, iron and aluminum are not the only metals that are (were) cast using sand casting methods. Pot metal, brass, pewter and lead were also cast this way. That raises the possibility of zinc, tin, copper, cadmium, antimony, lead, and other trace metals. Some of which are obviously a potential health risk depending upon the concentrations. I believe you're in iron country up there, but it might be wise to verify what metals are actually in the sand. In any industrial area (and WI is definitely industrial!) there are various kinds of foundries doing various things. If you can verify about when it was put down, and find out what the foundry was doing during that period, then you'll know. In recent times (post 1980, for example) waste was much more regulated and it's unlikely you got contaminated material after that. If it was always an iron foundry, fine.

    If in doubt, you can collect a composite sample from several areas and have it tested. Metals analysis is relatively cheap. Ask your ag extension people where you could have that done if you want to do it. There will be commercial labs around the state. It's cheap, probably a few tens of dollars.

    The foundry is probably trying to avoid trouble by not telling you anything, but it turns out the liability is there whether they talk to you or not. Ironically, by not acting friendly, they are more likely to cause suspicion in your mind, which is exactly what they should avoid.

    One question, you mentioned the 'required' 12" topsoil. Do you mean there is a local or state requirement for 12" topsoil when using foundry sand as fill?

    There may be nothing to worry about at all here, but not knowing anything about the situation, I thought it would be best to make you aware of the possibilities.