Software
Houzz Logo Print
lianhao

Bearing wall beam (PSL) issue

11 years ago

We are expanding one room, and now the project is paused, the new space is 14 foot wide, so the designer said let's use the PSL Beam. The PSL beam is 3 1/2" X 11 1/4" PSL FLUSH beam, and with Simpson ECCQ44SDS2.5 column cap, please see the attached picture. My contractor think the city inspector will question/fail us if we cut it without engineer's approval. The cut line is matching the old roof slop and gutter. Any suggestions or advice are welcome. other material(steel) or etc? The lesson I learned is that we should hire a structural engineer if there is a bearing wall.


Comments (9)

  • 11 years ago

    So hire one now. Your contractor is probably correct.

  • PRO
    11 years ago

    What's the worst case ? It sticks through the roof, gets weatherproofed with copper flashing, soldered and crimped. If not that, raise the roof or drop the beam.

    Casey

  • 11 years ago

    If you're thinking of cutting it on the red line that's marked, don't, you'll be buying a new beam. At least in our jurisdiction anything done with engineered lumber, even when it's obviously stronger than 2x construction needs an engineers stamp on the plan and then needs to be built per the plan. Cutting on the red line would substantially weaken that beam, seems very unlikely that it's over-specified by that much. You're going to need a plan b in all likelihood.

  • PRO
    11 years ago
    last modified: 11 years ago

    This has to be one of the most stupid things I've ever seen on here. What kind of contractor would place a beam where it obviously won't fit? Drop the beam; it ain't gonna be flush with the ceiling any more. Your structural engineer agrees with me.

  • 11 years ago

    Thanks all.. I am checking/hiring a structural engineer now. I was thinking to replace with a small cap with same gauge, but still need the structural engineer's opinion. Lower down the beam, it is hard to hide, since my ceiling is only 8 feet. I thought everyone will cut the beam in someway since if there is a slope always.

  • PRO
    11 years ago

    Brainstorm; simply install the beam flat-ways, problem solved. LOL

    Casey

  • 11 years ago
    last modified: 11 years ago

    how did you get this far along in the project only to now see the dilemma? your GC didn't address this earlier verbally before the labor and expense went into it? geez, ill tell you what..

  • 11 years ago

    Probably a ''handyman'' rather than a GC.