Bump, anyone able to help with recommendations on this?

Thanks!

Sorry for the delay!

ME 5.5: Sand. You know the drill. :-)

OM 4%: Not bad, actually, although I'd always mulch mow.

Sulfur 10: Normal!

Phosphorus 309: Kind of high (target is 200) but not a problem. This just throws the plants into luxury consumption levels, which is great.

Ca 56%: A touch low, so I did recommend calcitic lime in the recommendations. You know the drill.

Mg 22%: A bit high, but not a problem. Let's let it drift down naturally.

K 3.3%: While a tad low, it's not important and we'll let it wait until next year at minimum.

Minor Elements: I'd work on that iron with Milorganite if I were him. Boron requires a fix.

Boron <0.2: We use Milorganite as a carrier and 20 Mule Team Borax as the boron source. You can purchase 20 Mules at the grocery store in the laundry section. In a wheelbarrow or the like, dump the Milo. Spraying very, very lightly with water (I use a spray bottle like the kind people use to damp their clothes when they iron) will help the boron stick. Add the recommended amount of 20 Mule Team Borax and stir, spraying occasionally to get the stuff to stick to the Milo. Then apply over the recommended area. So if going for bag rate Milorganite (1 bag per 2,500 square feet), you'd add 10 tablespoons of 20 Mule Team Borax.

Recommendations:

May 1: Apply 3 pounds of calcitic lime per thousand square feet.

May 15: Apply 4 tablespoons of 20 Mule Team Borax per thousand square feet.

September 15: Apply 2 pounds of calcitic lime per thousand square feet.