Software
Houzz Logo Print
homeowner726

Need help with kitchen remodel problem: counter heights not the same

10 years ago

I just got new kitchen cabinets and yesterday the new
countertops were installed. There are two runs on opposite walls and the
counters ended up at different heights. One is 36 1/2" from the floor
and the other is 37" from the floor. The 1/2" is noticeable to me and
gives the kitchen an unbalanced feel. The contractor said it's because
the floors are uneven but he never mentioned before that the counters
might be different heights. Should I accept this? I am wondering why he
didn't shave one run of base cabs or shim the other run. (FYI, they are
custom cabinets.)

Comments (10)

  • 10 years ago
    last modified: 10 years ago

    Your cabinet installer is the issue, not your counter fabricator. The cabinets should be shimmed so that the top is 34 1/2" above the highest point in the room. Unless there is a large slope to the floor and the strategy to deal with that, and agreed to by you, was to have the two different runs be at different heights above the high spot in the floor.

    What he chose IS a valid choice to deal with the situation. He just should have talked about it with you and let you choose the lesser of two evils yourself. Homes are never level. You have to pick your poison.

  • 10 years ago

    I think your contractor should have discussed this with you. Maybe he didn't realize it beforehand?

    Our kitchen ceiling varies up to 2", I'd say. I don't know that anyone figured it out until the cabinets and moulding were going up, but our contractor and designer worked to make the cabinetry level without a trained eye noticing how uneven our ceiling is.

    My kitchen island is slightly higher than the surround, for prep purposes. I think it looks just fine. But, it might be different if one perimeter run was lower than another perimeter run.

    I hope you can work to solve this!

  • 10 years ago
    last modified: 10 years ago

    Thanks for your replies. They never mentioned uneven floors until after
    cabinets were installed and I asked why there was a gap between end
    panel and floor. They said they would use trim to hide the gap, which
    they did. They never mentioned counter height would be different because
    of it. Shaving 1/2" off toe kick of cabs in higher area would have been an easy fix because those cabs
    are only 12" deep and are hidden by 24" eating counter.

  • 10 years ago

    It seems like an adjustment will need to be made on your backsplash tile as well ... ?

  • 10 years ago

    Good point about backsplash.

  • 10 years ago

    there will only be a backsplash behind one of the counter runs. the other won't have a backsplash (thank goodness).

  • 10 years ago

    Doesn't sound significant to me.

  • 10 years ago

    Me either.


  • PRO
    10 years ago

    "Should I accept this?"


    You're the only one that can answer this, but he should have know better. Ascertaining the highest point in a cabinet installation is Beginner 101.


    If you're sitting on money, you're in a position of strength. You can choose to live with it for a discount or make him change it if it's going to drive you nuts.