Software
Houzz Logo Print
rhoffman54

can the stems be cut?

9 years ago
I want to install a number of these around my bar, but the ceiling heights are different (but I want to have the lights all hang at the same level). I am assuming that the stems are threaded, but is the thread needed at both the top and bottom, or might I be able to trim an inch of fraction thereof from one of the ends?
Lucera Industrial Factory Pendant, Brushed Nickel, Fixture Only · More Info

Comment (1)

  • 9 years ago

    As a suggestion, if you supplied two 1 inch stems; one 3 inch; one 7 inch and then two 12 inch stems, one could basically create a stem (not including the fixture nor the top housing) that has every inch covered from 1 to 36 (other than 6 inches) . In your current line-up one is limited to 4 inch increments...4;8;12;16;20;24;28;32;36 As you know, when placing a pendant over an island, a 4" difference might be too great.

Sponsored
River Mill Construction
Average rating: 5 out of 5 stars2 Reviews
Delaware County's Customer Focused General Contractor