Software
Houzz Logo Print
partim

Painting question - the wall-ceiling edge

8 years ago

I'll be repainting a room (from a dark color to a light one) where the previous painter made a pretty wobbly line, with a fair bit of the wobble going on the white ceiling. Given the color difference, it will show. We don't intend to paint the ceiling, which doesn't need it other than this problem.


I had thought of just going around the ceiling with flat white paint and painting the over-paint, then feathering out the edges. After it's dry we'll paint the wall. Do you think this will work?


Any other suggestions?



Comments (11)

  • 8 years ago

    This will work if you still have the can of ceiling paint. Otherwise, it will be very difficult to match the same white.

    partim thanked phuninthesun
  • 8 years ago

    Maybe, if its just less than a half inch, you wouldn't have to feather. If you have a crisp line, visually, you should be good, if you have the ceiling paint. If not, you could chip out a piece and try to match it. When its not an exact match feathering just makes it worse.

    partim thanked suzyq53
  • 8 years ago
    last modified: 8 years ago

    It is much less than half an inch. Less than 1/8 inch, and not everywhere. If it wasn't such a dark color it wouldn't show at all. @suzyq53 I think you are right and that feathering won't work. I may just go around with a very thin brush and do the edge before painting the wall. I am pretty sure we have leftover ceiling paint.

  • 8 years ago

    I had this issue in my bathroom. I used primer to go over the dark areas. I used an artist brush and you can't even tell the difference between it and the ceiling paint.

    partim thanked suedonim75
  • 8 years ago

    @suedonim75 how wide was your brush?

  • 8 years ago

    Prep and paint your walls. Go as close to where the wall and ceiling meet as you can WITHOUT getting your color on the ceiling. After the wall paint has cured (just to be safe), use painter's tape* to give you a straight line no more than 1/8" down from the seam. Then use your ceiling paint and an artist's brush, paint above the tape. (Lighter wall color - 1 coat, if darker, you might need a second coat.)

    *The only painter's tape I trust for this is green or yellow Frog tape.

    partim thanked Mary Elizabeth
  • 8 years ago
    last modified: 8 years ago

    I'm not sure if my instructions are clear enough. I use an angled brush to do the wall color at the ceiling, so it almost "rides" right up where the two meet. If your ceiling paint is a flat white, it will pretty much cover anything, so you don't need to be super careful. I know I'm a little OCD for details, but with a little practice, it goes pretty quick.

    Since no sheet rock seam is perfect, the slight drop on the wall gives the illusion of a straight line.

    partim thanked Mary Elizabeth
  • 8 years ago

    This is a fairly common thing to see and can usually be fixed by going up on the ceiling with the new wall color and just making a straight line there. We normally do this anyway since following the drywall line that is never perfect usually does not end up looking professional so we have to bypass the drywall line and make our own straight line. If the old color has gone up on the ceiling too far though where this is not possible, then you can use some ceiling paint to touch this up and it will most likely not be noticeable. It depends on the ceiling color too though as we know that many ceiling whites are not actually white. Once you start working on them, you may notice that it's some off-white or dirty white.

    partim thanked paintguy22
  • 8 years ago

    Thanks. Sounds like the options are to make a new straight line, either on the wall or on the ceiling. I sure wish the previous owners hadn't used such dark colors so I wouldn't have this issue!

  • 8 years ago

    @Partim, maybe 1/2 inch or so?

    partim thanked suedonim75