Software
Houzz Logo Print
webuser_986753635

Stove higher than counter

7 years ago
last modified: 7 years ago

So, I just had my new beautiful Fantasy Brown quartzite countertop installed. The contractor moved the (standard 36”) stove back in place and it’s over an inch higher than the counter! Obviously, the counter needed to be built up after the old countertop was removed. Should’t the contractor have known this? Isn’t he responsible for fixing it, even if it means removing the counter? I stopped payment on his final check in case he doesn’t take responsibility but feel bad he’s basically a nice guy.


Comments (24)

  • 7 years ago

    Have you checked the feet under the stove to see if you can lower them? There should be four independent feet that screw up and down to allow for leveling. They typically have more than an inch of travel so I would lower them as low as you can while maintaining the level of the stove. It may not go down all the way to counter height but perhaps you can get it a little closer.

    Ellen Slavitz thanked SirJohn
  • 7 years ago

    No, they’re all the way down. But, for resale, shouldn’t the counters be standard height?

  • 7 years ago

    How thick are the countertops? How high were your cabinets to start with?

    Ellen Slavitz thanked wiscokid
  • 7 years ago
    last modified: 7 years ago

    It’s fine. The only issue is when the range is lower than the counter. That’s a fire hazard. Nothings wrong with the range being higher. But, your range can’t be at its lowest adjustment. There’s at least an inch of adjustability built into most, starting at 36” AFF. 1/2” down, and 1/2” up. Start cranking on those legs if it bothers you.

    Ellen Slavitz thanked User
  • 7 years ago
    last modified: 7 years ago

    Did you have laminate counters before? When my laminate counters were removed and quartz installed (on my original cabinets) the quartz was about 1/2 inch shorter than the original laminate counters. My fabricator warned me that would happen when he came out to template and he said his company does not make sure that the cabinets are ready for when they come back to install, that it was on me to make sure everything was good to go.

    I called the company that made my cabinets (a local company) to have them come out to make sure they were sound enough to put quartz on. I asked the gentleman about building them up and he said most people don't bother because the difference isn't worth the time, expense and mess. I was getting a new backsplash anyway so I decided to leave them as they were (and they were still in great shape so I got the green light for the quartz).

    My range is about 1/2 inch higher than the countertops and I didn't even notice until I just went and measured. So it must have been completely even with the laminate ones.

    I would check your contract because I don't think this is the fabricator's fault. Do you have 2cm or 3cm quartzite?


    Edit to add that I got quotes from 3 different fabricators and in all 3, it was my responsibility to make sure the cabinets were ready for install.

    Ellen Slavitz thanked chocolatebunny123
  • 7 years ago

    I was in charge of making sure the cabinets were modified/adjusted for my preferred finish height. It would have been nice if your guy had talked to you about it, like Chocobunny's, but it's not his responsibility unless stated in the contract.

    Ellen Slavitz thanked alex9179
  • 7 years ago
    last modified: 7 years ago

    I had laminate. My contractor was doing all the before and after: the removal of the old countertop, cutting down of the breakfast bar, and all the plumbing and electrical, so essentially the remodelling. (He subbed to a fabricator.) Shouldn't he be the one to do some measuring to determine if there's a difference that needs to be addressed? I mean, it's 1 1/4" difference and looks sloppy, shoddy.

  • 7 years ago

    Yes, your contractor was in charge of that since he hired the fabricator. You're going to have to bring this to him and ask how he's going to remedy it.

    Ellen Slavitz thanked alex9179
  • 7 years ago

    Thanks, Alex.

  • 7 years ago

    looks fine to me

    Ellen Slavitz thanked kynsmama
  • 7 years ago
    last modified: 7 years ago

    Be prepared for him to put a lien on your house. There’s nothing functionally incorrect about that install. Your beef is aesthetic, and that’s the province of a designer, not a contractor. Since you didn’t hire a KD, and did this by the seat of your pants, it’s all on you. Start apologizing to the contractor and adjusting those legs and get used to it. Unless you want that lien.

  • PRO
    7 years ago

    Ellen:


    Is your dishwasher in yet?

  • 7 years ago

    " chocolatebunny123

    Did you have laminate counters before? When my laminate counters were removed and quartz installed (on my original cabinets) the quartz was about 1/2 inch shorter than the original laminate counters. "


    Not the case for me. I did have laminate counters, but the quartz was much thicker, My counters would up being 3/8" higher than the old counters, which I was fine with.

    Ellen Slavitz thanked Chessie
  • 7 years ago

    Another question, this one relating to the backsplash installation. My contractor insisted that the tile should extend behind the refrigerator. Doesn’t that look weird? Shouldn’t it align with the cabinet and the countertop?



  • PRO
    7 years ago

    I agree with Sammy. Things like this tend to happen when new floors are put in on top of old, after cabinets etc. Mitered edge in the budget?

  • 7 years ago

    It should go behind the refrigerator, or at least mine does. It also goes up a bit & down a bit so there are not weird gaps showing.

  • 7 years ago
    My range is almost an inch higher than my quartz countertop. I never thought about it till now. Why does it matter?
  • PRO
    7 years ago

    You had no grounds for stopping the payment on his check.

    You selected a new counter top material and he had it installed, that is on you!


    It looks much cleaner for the tile to continue behind the fridge, stopping at the counter top works as well but isn't as finished.

  • PRO
    7 years ago

    That stove is perfectly fine and very typical. I would still double check those feet you might get another 1/4 inch or so ( sometimes they get stuck )

    This also happens when floors are not under the cabinets.

    Quite often the tile is run behind the ref. There should have been a discussion about this before hand. But I see nothing wrong with what was done.

    BTW I have never had a customer tell me they couldn't sell their home because the stove was too high. I doubt anyone would even notice since they quite often look like that. You should be ok.

    Congrats on the new kitchen! Enjoy it!

    Ellen Slavitz thanked Debbi Washburn
  • 7 years ago
    last modified: 7 years ago

    Why are you trying to shaft your contractor here? You are acting as the job designer of the space. You should have elevation drawings and be looking at every measurement that needs to be drawn out to communicate with him. Anything that is written and drawn is what happens. You don't indicate what needs to happen properly on the front end? Then don't expect your contractor to be psychic.

    I hope you apologized and and handed him cash. That is the only way you'd ever get most of us back inside that house.

  • 7 years ago
    last modified: 7 years ago

    I have had too many experiences of contractors or other professionals doing crappy work. Stopping payment on a check is the equivalent of not paying until the job is done satisfactorily--isnt that why we initially pay a deposit? I don't have a lot of experience with this stuff so I dont know what is standard and what I should expect--that's why I'm asking these questions here. I hire professionals assuming they know better than I do. But things didnt look right to me. Every web site I looked at indicated that the stove should be level with the counter, so I figured that was a standard any contractor should know. Same with the tile questions.

  • PRO
    7 years ago

    I'd have to see a picture of the kitchen further back to see if the stove looks odd ... from the one picture you've shared it doesn't look bad.


    I do agree the tile behind the refrigerator looks strange because it's obvious where it stops. Either the whole area should have been tiled, or it should have stopped at the cabinet.

  • 7 years ago

    You agreed to pay, and renigged. That is breach of contract on your part.