Software
Houzz Logo Print
brian_vondedenroth

Replacing under sink kitchen cabinet floor




Under our kitchen sink the cabinet floor was rotten so i need to replace but am a little clueless about the best way to go about it. Do I need to replace the rosin paper layer that's torn and if so what's the best way to attach it to the subfloor? And the bigger issue, how would you build a wood support to anchor the cabinet floor given that there are pieces of hardwood floor under there at a different level than the wood subfloor? Do I just lay some wood in there, drill it to the hardwood pieces and leave it floating over the subfloor in the middle, or attach to the subfloor and leave gaps on each corner, or something else?

Comments (6)

  • PRO
    6 years ago

    Screw some perimeter blocking to the cabinet walls and put in a new cabinet bottom on top of those. I wouldn't fool with the floor under the cabinet as long as you've stopped the leak that caused the damage.

  • 6 years ago

    Is the subfloor wet or is that grease?

    I would remove the resin paper, clean up, dry thoroughly. Then two coats of pigmented shellac (BIN in the red can) to seal in any lingering odor.

    To replace the bottom, glue & screw cleats to the side of the cabinet and plop down new 3/4" plywood (not particle board, not MDF, not OSB. Nail the plywood to the cleats. You can caulk the seams, prime & paint the plywood. Add some sheet vinyl flooring cut to size, stick down vinyl tile, or even just some heavy vinyl coated wallpaper. I've even used the vinyl material from quality roll-up window shades for shelf liner.

    Looks like an easy replacement since the cabinets appear to be frameless. Saves you the problem of having to pop off the front face frame.

    No need to anchor the new bottom to the floor. That's just extra work; the old bottom wasn't connected to the floor...or, if it was, it didn't need to be.

  • 6 years ago

    Thanks for the suggestion Joseph. the cabinet walls are the same so so particle board with the predrilled holes that the cabinet floor was made of. You know cheap cabinets. There were dowels and screws in it holding up the previous particle board floor but I don't think they're in a condition to hold up anything else especially plywood. The leak is stopped and I think putting braces on the floor would be the sturdiest just not sure the best way to go about it with the varying heights of plywood subfloor, harwood inserts, and even a couple of thin shims between the hardwood and the bottom of the cabinet in the front only. So I'm dealing with three different heights.

  • 6 years ago

    Ignore the existing holes. Install the blocking/ cleats over the holes. Glue & screw. Careful w/ screws in particle board. Just a couple of screws per cleat plus the glue.

  • 6 years ago

    Thanks for the detailed response Cilantro. That sounds like a good way to go. It is water. When I was working under there I accidentally tripped the shut off valve. I dried it with some towels and have a fan going on it now. I was planning on waiting till everything is completely dry before continuing. What kind of cleats and screws do you think would work best for this?

  • PRO
    6 years ago

    1x and drywall screws; it's just a cabinet bottom.