Software
Houzz Logo Print
webuser_404650734

Range top sits higher than countertop

6 years ago

I purchased a Thermador range top to go into my kitchen remodel. When we went to install it, we saw that it sits higher than the countertop, with about a 1/4" gap around.




We looked at the range top and there was no way to adjust it's height. This was confirmed with a call to Thermador. And there's nothing we can do on the cabinet end.


Is there not some sort of standard for range top heights? There wasn't any option for the range top cabinet when we bought it, so we didn't think there would be an issue.


What to do?

Comments (10)

  • 6 years ago
    last modified: 6 years ago

    What model number is that range?


    The installation guide I just looked at shows the legs are adjustable.

  • 6 years ago

    no adjustable feet?

  • 6 years ago

    thank you. didn't see that.

  • 6 years ago
    last modified: 6 years ago

    It appears they used the support cleat method and the cleats or braces are too high. It should definitely sit right on the countertop with either method. Should be an easy fix. From the installation directions: The rangetop is designed to hang from the countertop by its flanges. The countertop however must be strong enough to support this rangetop. It may be necessary to add a supporting cleat along each side or a 2 x 4 corner brace (see page 10). Another alternative would be to construct a deck to set the rangetop on.


    If that's not the case, perhaps the opening is too small and it is sitting on something incorrectly.

  • 6 years ago

    My new range is like that. Adjustable feet don't help when there's a lip all the way around -- great for keeping stuff from dropping into the cracks, but you notice the extra inch or whatever of height if you're not tall. We've gotten used to it.


    New Kitchen 2016 -- wall 3 after · More Info


  • 6 years ago

    This is the Thermador PCG305P.


    The range top sits right on top of the cabinet.




    The cabinet was ordered from a catalog designed for a range top and is a fixed height. The countertop is ~1.5" thick which is normal. There's nothing to adjust....


  • 6 years ago

    "What to do?"

    Obviously the cabinet is preventing the range top from as expected: "The rangetop is designed to hang from the countertop by its flanges."* You're going to have to cut the cabinet to allow the range top to sit lower and flush with the countertop. It looks like you'll have to lower the doors too.

    *Page 6

  • PRO
    6 years ago
    last modified: 6 years ago

    "And there's nothing we can do on the cabinet end."


    Sure there is; alter the cabinet. It ain't all that. Don't be bashful. If you have to shorten the doors, crosscut the bottom veneer off, crosscut the door to length, and re-adhere the veneer. Test your saw blade for chipping first please.


    I'd check how the doors look before I altered them though. Depending on your cabinet layout, you may not be able to get back far enough to see they don't align perfectly at the bottom.

  • 6 years ago

    There's a full board underneath the range top.... Also, the cabinets are full overlay, so adjusting the height of things would make it not line up with the rest of the cabinets.


    I would prefer to not risk damaging the cabinet or having things not look good after sticking the veneer pieces back on.


    I heard about filler trim kits, but Thermador doesn't sell them. We're looking into just making our own with metal bars from the hardware store.