Software
Houzz Logo Print
winer812

Help with unstable paver steps on slope!

5 years ago

My husband and I are attempting a DIY project that seemed easy - and we are struggling! We are redoing a pathway that previously had small stones and pavers with new small stones and pavers. Sounds easy right? After taking out all the old we replaced the weed preventer fabric along the bottom, placed the pavers and then the small stones. The pavers were SO unstable (even after we tried to rake it flat as possible). We picked it all up and got sand and put sand under all of it. It was much better - but after the rain last night so much sand washed down and the pavers are again unstable. It’s a steeper slope than we would like but it’s the same slope that was there before so we know it’s possible to make the stones secure, somehow. Any suggestions? Attaching pics of it helps.

Comments (6)

  • 5 years ago

    I used paver base, no weed fabric.

  • 5 years ago

    The weed fabric is the mistake. Slippery when wet and messes up good drainage. The pavers need to be placed in contact with the earth, stable and individually with your sand base used for leveling things. Starting with a level (for the slope) tamped down base will help.

  • 5 years ago

    Using the landscape fabric is neither good nor bad :-) It is not necessarily a requirement but can be effective for controlling weed development in the pathway (one of its few valid uses) and also prevent migration of the base material into the underlying soil. Since it is not exposed when in a finished project, slipperiness is not an issue (have never found that to be a concern even when fully exposed) and since most are fully permeable materials, there is also minimal impact with regards to drainage. Fully half of the DIY walkway tutorials will recommend it - the rest will ignore it. It is really your choice.

    The stability of a paver walkway depends on how well the base is developed. A least 2-3 inches of a crushed rock gravel base material, leveled and compacted. Then a half inch to an inch of paver sand in which to seat the pavers. These need to be tamped in firmly, and then the gaps between filled with polymeric sand, gravel or river rock or low growing, groundcover type plants.

  • 5 years ago

    I'd try the sand again, but I'd mix with dry portland cement to stabilize the sand and gravel. I'd experiment with getting the paver exactly where I want, then tilt it up and spray the bed with a little water to encourage initial set. That way it should be resist a big rain. Another option is mixing the round gravel with cement and water and laying pavers on that. It gives a firm, but porous base.

  • 5 years ago
    last modified: 5 years ago

    In this DIY situation the fabric is a mistake. Placing the pavers (and the river rock) directly on the fabric is inhibiting even a half hearted attempt at a good base. While most landscape fabric is permeable, it is not the same kind or rate of permeable as the sand on top of it or the Florida sand below it. That changes things in a downpour. Any weed suppressing it might temporarily effect is not worth an unstable walkway. Lord, this is Florida. This is shifting sand. This not a slope. It's a slight pitch. The pavers should not be sitting on top of slippery landscape fabric with no base to hold on to.

  • 5 years ago
    last modified: 5 years ago

    Did you make a little terrace for each paver to sit on? If the paver is flat, or if the back of the paver tilts into the slope just a tiny bit, they'll be more likely to stay in place instead of slipping down hill. Also, I'd set each paver on earth or compacted gravel, not on sand.

Sponsored
AIS Renovations
Average rating: 4.5 out of 5 stars15 Reviews
Custom Craftsmanship & Construction Solutions in Franklin County, Ohio