Software
Houzz Logo Print
kelli_ga

Which screws for reinforcing subfloor?

5 years ago
last modified: 5 years ago

I will be installing tile on a wood subfloor over a recently encapsulated crawl space (dirt, vapor barrier, dehumidifier, brick skirt around house). This is a humid climate.

I will use 1/4” hardibacker and 36x6” plank porcelain tiles over a large area. I will install the tile myself. (I have done a similar job before over a smaller area in a dry climate with a concrete crawl space with 18x18” tile.)

Somewhere I read that the subfloor preferably should be screwed to the joists. It is currently nailed to the joists and has no noticeable movement.

The subfloor may be 1” thick plywood as I measured through the dryer vent hole, or it may be 3/4” plywood if the sides of that hole had swollen a bit. The people who did the encapsulation said the subfloor would be fine after dehumidification except for a small area I have to replace near a door.

Should I reinforce the subfloor to the joists with screws prior to hardibacker installation?

What size and length of screws should I use?

Should I use star drive or philip’s head? (I’m guessing Philip’s since there will be thinset applied to subfloor to secure hardibacker. If floor removal is ever done, thinset could be scraped out of philip’s more easily?)

How far apart should the screws be? (Current nails appear to be 8” apart over joists.)

As far as I can tell, this 30-year old house was extremely well constructed. It may have been a custom home. It was a rental before I bought it so I have exterior repairs to do and finishes to replace.

Thanks for any help or tips!

Comments (4)