Software
Houzz Logo Print
homeowner01460

Under cabinet range hood placement

4 years ago

We recently purchased this Proline under cabinet range hood https://www.prolinerangehoods.com/30-under-cabinet-range-hood-pljw-185-30.html and it has a depth of just under 19 inches. Our stove has a depth of 24 inches and I was wondering if anyone has advice on whether it would make sense to leave a gap of several inches between the back of the hood and the wall to provide better coverage of the front burners. We could do a stainless steel filler for the gap to address the appearance, but I am not sure how we would mount the hood if we went this route. Also, it can either vent straight back through the wall to the exterior or go up through the cabinets and then turn to go out out the wall. Is there a difference in performance one way or the other? The people at Proline said it would work fine either way but didn't say whether one was preferable to the other. My thought is it is probably more difficult to go straight back since you can't get your hands back there to properly connect to the duct, but I have no experience in this area and the online videos for installation are pretty poor. I appreciate any advice!

Comments (7)

  • 4 years ago
    last modified: 4 years ago

    Sorry, but I would exchange it for a hood that is deeper than 19". That is really shallow, as you are finding. Proline does sell 24" deep 30" wide hoods, but even 22" deep would be an improvement. Better to exchange the hood for a deeper one than jump through hoops to try to jerryrig it to be deeper which may not be fire safe over a cooktop.

    Regarding the duct, my understanding is that the fewer the turns of the duct, the more efficient is the exhaust, but I understand your point about accessibility. Still, you shouldn't need to access the duct after the initial installation, so I would vote for the option without the turn. Perhaps some experts will chime in.

    Erin H thanked RoyHobbs
  • 4 years ago

    Thanks, Roy. At this point we can't exchange it so any solution would need to apply to the hood we have. There is a longer story to that but not worth posting here, let's just say the hood model is the fixed variable.

  • 4 years ago

    You could sell it on Craig's List. With all the amount of renovating going on, you'd sell a new hood no problem, with just a slight loss. I understand if you don't want to, just thought I'd suggest.

  • 4 years ago

    It's a good suggestion but I think it might cause problems in my marriage as my husband picked it out. I would much rather suffer through a mediocre range hood than suggest that he made a bad pick :)

  • 4 years ago

    It is against an exterior wall so we have the option to do either straight back or out. HVAC professionals are installing the ductwork.

  • 4 years ago

    Shorter duct is better unless the longer path provides room for a silencer and the blower is outside instead of in the hood.

    There are a few threads here on spacing out and covering with stainless steel.

    Don't expect spectacular performance (capture and containment) from a hood that is undersized. Perhaps cooking liver or something on a front burner will motivate the selector to suggest an upgrade. :)

    Erin H thanked kaseki