Software
Houzz Logo Print
bill_klein58

Suggestion for Range Hood Insert (brand/model)

4 years ago

Hello! We are remodeling our kitchen and need to purchase a range hood insert (we are building an enclosure). We have been unhappy with the noise/performance of our past hoods, so want to splurge on this if it'll help us. Our requirements:

- Width: ~30"

- Depth: ~20"

- Duct size: 6" (actually we have 10x4 so slight more, but much less than 8")

- Powerful (~600cfm?) but also quiet! :)

Any help for a best-brand suggestion would be greatly appreciated.

Comments (4)

  • 4 years ago
    last modified: 4 years ago
  • 4 years ago

    I read that article. Mostly quite interesting but I take some issue with the discussion about capture area. Of course this is a variable of how high above the cooktop the hood is. Therefore, if a deeper hood means putting it much higher (so that you can actually use the cooktop) then it's likely a poor compromise I would think...

  • 4 years ago

    "but I take some issue with the discussion about capture area."

    How so?


  • 4 years ago

    Capture area (hood intake aperture area) should overlap the expanding cooking plumes. Assume at least 10 degrees from vertical for all points across the top area of all likely pots and pans to be used on any or the hobs, and add some for burner flames if applicable. This implies that the capture area has to grow with height, and doesn't account for plume deviations due to cross drafts and human motion turbulence.

    Capture areas smaller than this will likely miss capturing effluent and the effluent will spread into the house where it either condenses on walls and fabrics, or is eventually removed from air replacement.

    Numerous threads here discuss sizing the hood, sizing the flow rate to assure that even if the plumes are captured they don't reflect out of the hood, sizing the duct for best balance between grease collection due to impingement and grease collection due to condensation, blower rated CFM to achieve desired CFM, and make-up air (MUA).

    Quieting of the hood system can be achieved using a remote blower and intermediate silencer such as Fantech makes.

    A 6-inch duct should be limited to 400 CFM, so a 600 CFM rated blower might be appropriate given typical pressure losses and blower fan curves. 10 x 4 duct, from a pressure loss point of view is equivalent to 5.7-inch round duct. (IRC Table M1506.2).

    For a given blower restricted by duct size, it is probably better to use a larger hood and miss out on some extreme cooking capture due to insufficient CFM, then to miss out full plume capture on all cooking due to insufficient area to overlap the plumes.