Software
Houzz Logo Print
dana_dn

Design help needed for new driveway

4 years ago
last modified: 4 years ago

We are planning to do a new driveway, concrete with paver border or just concrete (not sure yet). This old driveway is too small (2 cars), always walking on the grass after getting out of the car. The new one needs to be for 3 cars and would be nice to connect it with a front walkway. Curved or angled with straight lines? All suggestions would be appreciated! Thanks!






Comments (10)

  • PRO
    4 years ago

    hey you can do an addition with paver it will look really good.

    D DN thanked Tonioli Brick Pavers
  • 4 years ago

    Don't do pavers.

    I don't care how good the prep is, you will eventually experience one or more of the following:

    - Settling, low spots, 'pot holes', heaving/unevenness, grass/weed growth between pavers


    You say it "needs to be for 3 cars". Does that mean you want the driveway to be 30+' wide? Could you just have a parking pad off to the right instead?

    D DN thanked booty bums
  • 4 years ago

    yes, it might be parking pad off the right, but I want it to look good and I am not sure if should we go with a straight line or curve?

  • 4 years ago

    Will you also add space to the left side of the driveway? So that if someone parks behind the garage door on the left, they have room to step out?

    As far as shape, could there be a series of stepped squares, like a curve done with the squares on graph paper?

    D DN thanked bpath
  • 4 years ago

    We love our pavers and have zero issues with them. We were restricted on how much non permeable material we can have on our lot so cannot do more. If we could have had more I would have done a pull in park in pad. Similar to what I crudely added in pic below. Everything so far seems angular and not curved so I would keep same.

    D DN thanked WestCoast Hopeful
  • 4 years ago

    So you have two cars in the garage and three more cars?

  • 4 years ago

    I have NEVER seen a paver patio that didn't have one or more of the issues I mentioned after a certain number of years from being installed.

    Just a few examples...

    https://www.youtube.com/watch?v=eI01afj9Hio

    https://www.youtube.com/watch?v=ZvM7KZ-1oIA


    With concrete, you have one monolithic slab tied together with rebar, wire remesh, fiber mesh, ect. With pavers, you literally have thousands of tiny individual bricks floating around.

    And with those thousands of individual bricks comes thousands of linear feet of cracks for grass/weeds to grow in between.

    D DN thanked booty bums
  • 4 years ago

    D DN -

    I would do a parking pad similar to what WestCoast Hopeful illustrated. I'd also extend the width of the existing driveway by 1-2' on each side, so you aren't stepping out onto grass when exiting your vehicles.

    Use a decorative stamped concrete for the 1-2' extensions and parking pad. That will allow you to keep the existing driveway (assuming it is in good shape) without the new work looking like an obvious add-on.

    I don't understand your comment on adding curves. Your garage in almost perfectly parallel to the street, and there is only 26' of driveway. How would you add curves in that 26' distance, and still have the driveway line up to the existing garage and street curb cut?

    D DN thanked booty bums
  • 4 years ago

    Pavers can look great if you realize they require more maintenance then a concrete drive. Like a lawn requires more than a drive. They don't require as much as a lawn. So, you're ahead there.

    D DN thanked dan1888
Sponsored
Mary Shipley Interiors
Average rating: 4.8 out of 5 stars34 Reviews
Columbus OH Premier Interior Designer 10x Best of Houzz