Software
Houzz Logo Print
garry_crabbsii

Flush birdbox fascia

3 years ago

My house was built in 1960 and some of the designs from that era are questionable.The "bird box"fascia is flush with the sheathing on the side wall.I am getting ready to install house wrap and vinyl siding.since I do not have a typical birdbox can I just vinyl side it ? My roof overhang on the gable end of the house is only 1-1/2" so it would be impossible to build a traditional bird box

Comments (8)

  • PRO
    3 years ago

    I am unfamiliar with the term "bird box".

  • 3 years ago

    The angle piece at the edge of the roof.usually the gable end overhangs the house by about a foot at the end of the roof that is boxed in to enclose the fascia this boxed enclosure is referred to as a "birdbox"

  • 3 years ago

    Enclose the soffit end from the front of the house

  • 3 years ago

    One house, we had with the flush type, did have a trim board right up next to the roofline, with miter where it met the other side at peak of house. That trim board, also covered the birdbox on the end. I am going to post a picture where the siding goes up, but, in my opinion, the trim, is a much nicer look, than siding all the way up.

    Even on this one all the way up;, there is a small trim board. Personally, I do not think, this is a good look. The picture, below is how it was on our house, and its a much nicer look, than the picture above.




  • 3 years ago

    Yes,that's what I am looking for.I like how you did your house.i think I am going to make one different twist on your idea.I am going to take my vinyl corner post all the way to the roof and have my top trim piece butt  into the post on an angle isolating the birdbox piece,the birdbox is wood and I may simply caulk and paint well.thanks for the idea

  • 3 years ago

    Good Luck. Post a picture when you have that side all done.

  • 3 years ago

    Just because your shingles do not overhang more than 1 1/2" (??) does not mean you can't have a "bird box." Since the roof and vinyl siding wasn't detailed to not have one, you need a fascia rake board to accept your roof drip edge anyway. The "bird box" can just be the same fascia board, 3/4", 5/8", 5/4, whatever material you choose and will fit under the shingles with a better overhang than 1 1/2" for them. The biggest reason to do a "bird box" is because the eaves are not uniform - the right side is much smaller and higher than the left.

    Extending the corner trim by cutting it as you commented last would not work, be watertight, or look good at all.

  • 3 years ago

    well here is how things came out