Software
Houzz Logo Print
snappity

Soapstone edge profile

3 years ago

Our kitchen is underway! I am going in the next week to Vermont Soapstone to pick out my slabs for my counters (no island, just perimeter, if that matters) and am thinking about the edge profile. I know I don't want sharp edges, but am deciding among radius, double radius, or bullnose. The cabinets are slab front.


I am thinking between double radius or bullnose, but if there are practical reasons to choose one of these three over the other two, I would love to know! Thanks!



Comments (12)

  • 3 years ago
    last modified: 3 years ago

    We have an eased edge on our soapstone, which I guess is the radius on your chart. Of the two you favor, I’d go with the double radius. To me that will go better with the slab doors on your cabs. A full bullnose is less sleek/modern.


  • 3 years ago

    Thanks, darbuka - one of the reasons I am drawn to the bullnose is to soften the kitchen a bit. I am also looking at doing my open shelves with a red oak bullnose stair tread (just 2 24-30" shelves to display my le creuset, not a full wall) but am not sure if there are practical considerations between half radius/ radius/ bullnose. Function > form for me, so if there is a functional preference, I am all ears!


    I am super excited to pick my slabs on Friday and be even closer to the stoner club! :)

  • 3 years ago

    “if there are practical considerations between half radius/ radius/ bullnose. Function > form for me, so if there is a functional preference, I am all ears!”

    Rule of thumb: the more rounded the edge, the less prone to chipping…which is why a straight edge is never a good idea.

    I chose the eased edge (radius), as my variety (Belvedere) is very hard, so I wasn’t so concerned about chipping…, and I wanted a simple, more contemporary look. However, since you’ll have slab doors, I can see why you’d want to soften the look of the kitchen.

    Here is Teixeira’s chart:


    snappity thanked darbuka
  • 3 years ago

    I like to close the loop on these questions — I ended up going full bullnose and love it! The fabricators were surprised (made SURE I knew what I was saying) and then excited to do it, they don’t get that request often, I guess!





  • 3 years ago

    Your soapstone is beautiful.

  • 3 years ago

    Beautiful! Love the runnels!

    Vermont Soapstone did a wonderful job!


    snappity thanked darbuka
  • 3 years ago

    @darbuka you can imagine how excited I was to see these go in! Thank you!

  • 3 years ago

    I knew Vermont Soapstone would do right by you.

    Such a gorgeous light grey. Do you plan to oil…or will you let the stone darken on it’s own?

  • 3 years ago

    Still debating - tested out milkpaint wax on our little mini bar area, and mineral oil on the spot the toaster oven goes, just to feel it out. My husband loves the dark look (and has had very few strong opinions on the reno, so I am inclined to try it dark for a while! But not doing any more until we have running water again. :)





  • 3 years ago

    @snappity - your soapstone is SO gorgeous! i agree with @darbuka - the darker is so striking.

  • 3 years ago

    Yes, I think we will wax it - I don’t like the feel of the area we oiled as much as I like the waxed sample. Thank you!