Software
Houzz Logo Print
webuser_302199450

Kitchen stone benchtop. Tapware cut in wrong place

12 minutes ago
last modified: 7 minutes ago

Looking for advice from kitchen manufacturers, cabinetmakers, stone fabricators or anyone who has experienced a similar issue.
A stone fabricator has cut the tap hole in my new kitchen benchtop in the wrong position. The tap hole is 105mm from the sink, when the required positioning was 50mm.
The plumber is unable to install the tapware in its current position.The stone fabricator are blaming the markings on the cabinet maker's template, but neither is accepting responsibility for the error.
The template contained a marking 'T', which referred to the rear of the underneath cabinetry, NOT the tapware position. The stone measure is in the photo attached.My understanding is that tap-hole locations are normally specifically identified on drawings and templates, with a marked centre round circle marking and dimensions.
I've investigated alternative solutions to fix it, including additional larger tapware and patching the existing hole, but neither is a viable option.
I'm now concerned that the benchtop will need replacing. And if both 2 parties can't agree what next ? Legal
My questions are:Who is normally responsible for confirming tap-hole positioning before stone fabrication? I understand it's final check is at the stone measure.Should the fabricator query unclear template markings before cutting?Is there an industry standard or accepted procedure for communicating tap-hole locations?If both businesses are responsible for the error, what would be a reasonable resolution?

Sponsored
Urban Upkeep LLC
Average rating: 5 out of 5 stars6 Reviews
Columbus High Quality Painting Expert