Software
Houzz Logo Print
bethfl

Help Please - Planting Diffenbachia rooting/plantlet in container

16 years ago

Hi. Posted this in "Propagation" forum but I'm still not sure about what to do and I'm so afraid of losing this old family plant. Again, any advice is so appreciated!!

This diffenbachia has been in our family for years and I'm trying to start new ones for relatives. No sure how to attach a photo so I'll try to describe it. I have three right now that are in a dish of water, laying horizontally - a thick stem about an inch and a half in diameter. New roots are growing at the bottom and new stems have formed at the"top." This is where I've run into problems before after placing in soil . . . the thick stem begins to rot or shrivel. I've read that some people keep them in water but I'd rather plant. Any advice is so appreciated! Also, should I try another forum?

Thanks!

Beth in SC

Comments (4)

  • 16 years ago

    This is something I wrote and have posted before. Parts of it might be a little technical, but you will easily get the drift. Let me know if you have questions.

    Though roots form readily and often seemingly more quickly on many plants propagated in water, the roots produced are quite different from those produced in a soil-like or highly aerated medium (perlite - screened Turface - calcined DE - seed starting mix, e.g.). Physiologically, you will find these roots to be much more brittle than normal roots due to a much higher percentage of aerenchyma (a tissue with a greater percentage of intercellular air spaces than normal parenchyma).

    Aerenchymous tissue is filled with airy compartments. It usually forms in already rooted plants as a result of highly selective cell death and dissolution in the root cortex in response to hypoxic conditions in the rhizosphere (root zone). There are 2 types of aerenchymous tissue. One type is formed by cell differentiation and subsequent collapse, and the other type is formed by cell separation without collapse ( as in water-rooted plants). In both cases, the long continuous air spaces allow diffusion of oxygen (and probably ethylene) from shoots to roots that would normally be unavailable to plants with roots growing in hypoxic media. In fresh cuttings placed in water, aerenchymous tissue forms due to the same hypoxic conditions w/o cell death & dissolution.

    Note too, that under hypoxic (airless - low O2 levels) conditions, ethylene is necessary for aerenchyma to form. This parallels the fact that low oxygen concentrations, as found in water rooting, generally stimulate trees (I'm a tree guy) and other plants to produce ethylene. For a long while it was believed that high levels of ethylene stimulate adventitious root formation, but lots of recent research proves the reverse to be true. Under hypoxic conditions, like submergence in water, ethylene actually slows down adventitious root formation and elongation.

    If you wish to eventually plant your rooted cuttings in soil, it is probably best not to root them in water because of the frequent difficulty in transplanting them to soil. The brittle "water-formed" roots often break during transplant & those that don't break are very poor at water absorption and often die. The effect is equivalent to beginning the cutting process over again with a cutting in which vitality has likely been reduced.

    If you do a side by side comparison of cuttings rooted in water & cuttings rooted in soil, the cuttings in soil will always (for an extremely high percentage of plants) have a leg up in development on those moved from water to a soil medium for the reasons outlined above.

    Al

  • 16 years ago

    Beth, prepare small containers for each of your three rooted cuttings. Be sure to use a good quality potting medium that is very porous. You might want to add a handful of extra perlite to the mix just to be sure. Porosity is important.

    Water the soil well before installing the cuttings. Then, dig out a shallow hole wide enough to receive the cutting, still laying on its side. Carefully scoop enough of the potting medium over the cutting to cover it, but you really don't have to worry about that too much. If the top of the horizontal piece is exposed, that's fine, even preferred. Water again and place in a warm location with some decent but never direct light.

    Hopefully, your cuttings will transition to terrestrial conditions. That can be a difficult move to make, for many plant species. It really is better, for the plant, to start cuttings in a solid medium of some sort, and not water.

    BUT, if they die, don't hesitate to take more cuttings. Allow the cane pieces to dry out for a couple of hours, and you may wish to use a powdered rooting compound. This time, place the pieces horizontally onto the well-drained medium, burying them about 1/2 way. Water them in well and keep them moist, but never saturated. That's why a very porous medium is important.

    Remember, you're going to be burying the pieces on their side, leaving the top half of the stem exposed. And don't be tempted to pick them up and inspect them! You don't have to 'see' the roots develop.

    Here is a link that might be useful: {{gwi:49785}}

  • 16 years ago

    Thank you so much! I'd tried before a few times with hormone powder on one side of the thick stem and nothing happened or it would rot. I am so happy to get these this far! Will get some perlite and do it right. I really do appreciate y'all's time and consideration in your replies!

    Beth :)

  • 16 years ago

    You are very welcome, Beth. Don't hesitate to let me know if I can help.