What is the correct sequence and screws to adjust the High and low throttle?
I replaced the gov linkage spring but may have it in the wrong hole. I really don't quite understand why it seemed to run fine before I replaced the spring.
I did not mess with the screws until I noticed that if I pushed the gov arm forward I got a lot more RPM.
As is, I need a lot more RPM when the PTO and Transmission are engaged.
I did notice that the linkage arm to the gov was somewhat bent and I straightened it. Amazed at the difference that a small bend would effect the throttle!
Could use a small tutorial. Kinda feelin sheepish I can align a wind turbine generator 250 ft. up but not figure out a float valve carb (grin)
bill_kapaun
windclimberOriginal Author
Related Professionals
North Adams Landscape Architects & Landscape Designers · Manchester Landscape Architects & Landscape Designers · Oneonta Landscape Architects & Landscape Designers · Huntsville Landscape Contractors · Amherst Landscape Contractors · South Sioux City Landscape Contractors · Trenton Landscape Contractors · Hudson Landscape Contractors · San Francisco Landscape Contractors · Olympia Landscape Contractors · Montréal Landscape Contractors · Springfield Stone, Pavers & Concrete · Charleston Stone, Pavers & Concrete · Providence Stone, Pavers & Concrete · Colorado Springs Stone, Pavers & ConcretewindclimberOriginal Author
bill_kapaun
windclimberOriginal Author