Software
Houzz Logo Print
bmorton_gw

Need help with white gt-2055

16 years ago

I just got this tractor and noticed the wiring has been chewed by rats or mice. I am not a mechanic, but I want to fix it myself with my son. Im hoping someone can tell me where to get a wiring diagram for this tractor or at least guide me through the wires to at least get it to crank. the swith is also missing. It has a 20 horse v-twin briggs motor.

in advance thanks for your time and help

bruce morton

Comments (8)

  • 16 years ago

    You will have to post all of the numbers pertaining to your tractor. those numbers will be on stickers, or plates, affixed in various locations on the tractor, and on the engine shrouding that is bolted to the engine block. Some engines have the numbers stamped into the tin shrouding of the engine. Another place, on some engines will be on the valve cover, if it has overhead valves.
    With your posting of those numbers, someone will be able to help you in your working on the machine. Might take a short while, but there are a lot of knowlegable folk here who are ready and willing to help you!
    Rusty Jones

  • 16 years ago

    here are all i can find
    20hp briggs v-twin
    model 351447
    type 0180-01
    code 9409 1511 4952
    thanks for the help.
    allthe safety stuff is gone, and i noticed theres not a switch or a silenod on it .

  • 16 years ago

    The MTD website would need the model # under the seat. You didn't say what your purpose for the tractor was. To get it to crank, you need a switch that supplies power to a small terminal on a 3 pole solenoid (basic solenoid w/ 2 large lugs and 1 small terminal.) battery cable on one lug and lead to the starter on the other. Solenoid grounded to frame. Supply power to the switch w/ a fused wire from the battery. Power must also go to the little solenoid under the carb if equipped. Now it starts and runs. Great. How do you shut it off? Small wire from the coil is grounded temporarily to kill the engine. Alternator output should find its way to the battery provided it is DC. This will make it start, run and stop. Safety switches are a necessity- especially if you are running a deck.

  • 16 years ago

    Ok, with your help i got the switch going, but now the driveshaft seems to be locked up to the transmission. Everything is out of gear and all that and the enginge trys to turn but just goes so far. i took the shaft loose and apparently its either gone or stuck. and as usuall, i dont know where to start

    thanks, thanks, thanks bmorton Rosa Alabama

  • 16 years ago

    Brake arm stuck?

  • 16 years ago

    " Everything is out of gear and all that and the enginge trys to turn but just goes so far."

    Whoa, hold on there a minute. Take the spark plugs out and see if the engine spins good with the plugs out. If it does, you probably need to adjust the valves properly so the compression release feature can function correctly. Briggs is famous/notorious for this.

  • 16 years ago

    Mownie may have saved the day. My quick read made me think the engine was going.Let us know how you fared.

  • 16 years ago

    I got to looking alittle closer, and there are two driveshafts. one for transmission and one for the deck. I took the one off the deck and now the one to the trans turns. i dont understand why the deck was engaged all the time. i moved the lever and the idler pulley backed off but the shaft still was engaged. the shaft to the trans will sin no matter what i put what in. does the engine have to be running? Thanks guys for your help. im not as scared of it as i was
    bmorton

Sponsored