I have a craftsman 18' 40cc chainsaw that is only about a year old.
I haden't run it for awhile then the other day I cranked it up & a large amount of oil came out the bottom.I then took it apart & cleaned the guide bar making sure all the the channels were clear.There is a thin metal plate where the oil enters the saw from the oil tank.I remover this & cleaned as best I could.I didn't mess with any of the tubes or anything.
I was just wondering if there is any way to control the oil flow or is it possible that some of the tubes under the thin metal plate could have become disconnected?
Any info is appreciated
rcmoser
Related Professionals
Louisville Landscape Architects & Landscape Designers · Champaign Landscape Architects & Landscape Designers · Pittsfield Landscape Architects & Landscape Designers · Newark Landscape Architects & Landscape Designers · Akron Landscape Architects & Landscape Designers · Salinas Landscape Architects & Landscape Designers · Montgomery Landscape Contractors · Kissimmee Landscape Contractors · Toms River Landscape Contractors · Davenport Landscape Contractors · Albuquerque Landscape Contractors · Twin Falls Landscape Contractors · Provo Landscape Contractors · Raleigh Tile and Stone Contractors · Saint George Tile and Stone Contractors