Software
Houzz Logo Print
chueh_gw

stake weeping cherry the right way???

18 years ago

I used 2 sticks to straighten the major trucks of my weeping cherry tree, although it has not been cooporating much. I don't think I have been doing it right. The sticks are too short. I will stake by using much taller sticks. I am not sure which part I should support it up. I want to do it right this time.

Please see the entire picture of it. What a mess!!!

{{gwi:482020}}

The trunk of the tree splits into two, far apart.... I have never seen one like it.

{{gwi:482022}}

Would you please tell me which one I should stake? The red lines are the sticks I use now to support the tree. The blue marks ( A & B) are the two split trunk, also the thickest. The yellow (c) and the green (D) marked ones are pretty similar to the blue parts, although they are slightly thinner. I am guessing I will stake both the blue parts. Am I right? Or is there any way to stake it? Please advice me... Thank you.... I would love to have a normal look of a weeping cherry.....

{{gwi:482026}}

Comments (7)

  • 18 years ago

    first off... time to get rid of 'sticks' ... link below to what i use.. and the first pic is how i do it... the bammer isnt necessary if you have a sledge hammer... but for 20 bucks it sure makes it easier ...

    your pix make it pretty hard...

    but lets step back ... do you want a tree form???? if yes... then its time to start pruning up the lower branches .... perhaps taking out the green and yellow ones completely ... do you know how to properly prune them???

    and then i would consider denuding the blues up a foot or two .... starting to develop a proper trunk ....

    then i would step back.. and decide if i want two major trunks or one.. and then decide ... which of the blues have to go ....

    THEN. AND ONLY THEN.. would i start to think about how to stake the remaining plant ...

    are you with me so far ?????

    many weepers are grafted onto standards that vary in height... yours isnt .... so you are going to have to TRAIN IT to the height you want ... and if you are thinking at least 6 feet ... you may as well put in a 6 foot stake now ...

    BTW... how recent was transplant????? it will matter with harsh pruning

    there is never any hurry with pruning .... so lets define your goals...

    good luck
    ken

    Here is a link that might be useful: fence posts

  • 18 years ago

    Weeping cherries are almost always grafted, which yours appears not to be. Shoots of Higan cherry (Prunus x subhirtella 'Pendula' or other cultivars) are grafted on upright cherry rootstock at a designated height. I doubt you will ever achieve the look of a "normal" weeping cherry with this plant and staking it is not going to help. First, there is no clear dominant trunk that would provide a tree form - without this you are pretty much destined to have at best a large, messy looking shrub with pendulous (maybe) branches. You may be better off getting rid of this plant (I agree - it IS a mess) and look for a correctly grafted weeper.

    Was this sold to you as a weeping cherry tree? If so, I'd be very leery of doing any more business with that nursery.

  • 18 years ago

    I am with you guys. Thank you very much.

    It was my ignorance to think that the tree itself would turn into a proper tree "form", when I got the seedling one and a half years ago. I could have complained about it to the nursery, for it had one year warranty. However, the tree has been getting messy and messier. Now, I cannot complain it to the nursery, for it's over a year.

    No matter what now, I don't wish to get rid of this tree. It is a messy abnormal weeping cherry, unlike anything in an ad picture that the nursery used. However, it is a life, especially it is growing pretty well, except Japanese beetles bothering it.

    If I can do anything to try to train the tree, I would and will, even with only the slightest chance to make it into anything close to a tree form. I want it to be the average height, much higher than 6 ft, I assume.

    Since I don't prune trees much, I don't remember how to properly prune a tree. However, I have some books handy, and I can always read the pruning sections when I need it. If you have any suggestions of pruning, please advice me. Actually, I was a little confused about how to prune a tree to make it grow the direction I want.

    If I were to get rid of one of the trunks, how do I make the remaining one straight? neither one grows straight; they pretty much grow in a 45 degree angle....I cannot anticipate how the only trunk would grow "side way" without the other. At least now, they both depart from the center, and they kind of balance out on each other. I am a little afraid of the result once I dare doing something. However, I really really really want a TREE looking tree.

    People have asked me what it is the strange looking THING. I feel embarrassed somewhat. I want a TREE

  • 18 years ago

    trees develop atypical dominance... unless i am getting my terms confused ...

    they want to grow up and straight ...

    often.. i prune one year.. let it grow another year.. then wait to decide how to stake it ....

    it can and will figure it all out on its own.. over the next decade... the issue is.. how do we encourage it ..

    pick one of the two major leaders.. and cut the other off ... then snap a new pic.. and we will decide how to stake it...

    ken

  • 18 years ago

    Do you mean apical dominance?

  • 18 years ago

    Very common weeping cherry 'Snofozam' is grown from cuttings and offered in a variety of shapes. Yours doesn't look that different from one of these trained deliberately to be snaking or otherwise something other than the "usual straight beanpole" (Grant & Grant). Maybe you can just let it stay that way. Selecting one of the trunks near the center could allow you to develop a higher center and more layered specimen via tying that stem to a firm stake and training it up it. If you succeeded in developing a new, elevated head of larger size than perhaps the remaining, untrained stems could even then be cut out. But since this plant has already grown some time in another direction it might be best to leave it in the growth style it already has. One somewhat taller portion in the center (resulting from staking and tying) with lower branches around it, forming a layered mound like that produced by a weeping laceleaf Japanese maple might what to aim for.

    Many uses
    and forms:
    bottom bud, top
    graft, ground
    cover, espalier,
    arbor, trellis,
    cascade over
    a wall

    Here is a link that might be useful: SNOW FOUNTAINSpdf

  • 18 years ago

    I agree with bboy - this is not likely ever to assume the habit of a typical tree. Growth is too far along to stake either of the two primary branches/leaders to achieve any kind of erect, vertical growth. They will always have that directional lean to them at the base, although you might encourage more upright growth by staking the outer portions.

    I'd be inclined to allow it to assume its apparently natural shrubby habit and perhaps do some selective lower branch removal down the road in a few seasons. But if you must keep it yet want a 'real' tree, purchase another and place somewhere else on your property. You're not going to get that look from this one.