Software
Houzz Logo Print
lleopardggecko

Problem

21 years ago

So I've been using two 15 watt flourescent tubes (825 lumens each) to light my terrarium for the past few weeks, They've been working great so far, but I decided that I needed more light yesterday so I bought two 19 watt compact flourescents (equivalent to 75 watts each-1100 lumens each). I tried using all the lights at the same time, tubes and new bulbs, and the heat in my terrarium was just too much, even with my fan blowing over it. So what should I do? Ditch the tubes and just use my two new CFs? Or keep the tubes and maybe just use one of the CFs or something. Help!

Comments (10)

  • 21 years ago

    are the tubes directly exposed to the inside or are they separted with a piece of plexi?

    What temps are you running? It just seem odd that you would run that much warmer by adding the 2 CFs that are separated with glass and a bit of vent room between the reflector dishes.

  • 21 years ago

    Hello LLeopardGGecko, i've seen your Terrarium in the pics last thread. my advice would be sticking with the two 15 Watts Tubes.if the two 15 watts are used, plus the two 19 watt flourecent are used, the equivalent of watts would be 68(added together), which is too much light for the plants. and that could be a problem by adding heat with the light bulbs alone. if i were you, i would just stick to the two 15 flourecent tubes , two 15 watt flourecent tubes usually work well for many terrarium Enthutiasts(since you said it had work well for you.)But, it's better if you remove the two 19 compact Flourecents plus you use the aluminum in the back of the terrarium to create more reflection from the light.. too much heat(and light) may damage the foliage of your plants. what you can do is either this;1) remove the two 19 watt compact flourecents, Or.. 2) Decrease the lightning hours of your terrarium. either one works fine. Hope this Helps. do whatever works for you.. but i would just use the two 15 Watts flourecent tubes..

  • 21 years ago

    It runs about 87 degrees as opposed to the 80ish I was getting before I added them. Perhaps I'm putting them too close to the terrarium glass? Check out the terrarum picture page on this board, I have a picture of how I have it set up (bottom of the thread).

  • 21 years ago

    You need to take into consideration that the CFs and maybe the Tubes are going through plexi on top and glass on the side... so your lumens will drop.

    Do the hoods you have for the CFs have vent holes near the base where the ballist of the bulb screws in?

  • 21 years ago

    Well my tubes on top aren't going through any glass or plexiglass, so no lumens drop there.

    The CFs are going through the side glass. They have holes in the hoods for ventilation. I don't know what to do, lol.

  • 21 years ago

    I would move the CF lights back to create more space between the light and the glass.
    The light will generate heat ofcause, not nearly as much as an incandesent, but this heat will heat the glass which will heat the entire terrarium.
    I feel if you create abit of space by sliding each CF back a little more away from the terrarium you may see a big drop.

    Also you could use your hand to get an idea of the heat output from these bulbs (dont touch but see where the heat extends too so you can get an idea)
    If you can get the heat to drop to an ideal temp that you are happy with (what about more ventalation if possible? then Im sure your plants will thrive.

    I dont think the amount of light you have running is too much, especially since its not all coming from one direction but is spread out around the terrarium.
    Further, your 15watt bulbs in the top are fine that they dont go through glass which will drop their output, this is good because they are weaker output bulbs.
    The CF as you said does however which will indeed impact on the total light getting through.

    If we get a solution to your heat you will have a good setup and your plants will love it.
    Your fan inside is not really a benefit to cool it much I think because with the humidity it ends up been what we call a "berg wind" in South frica which means " mountain wind)
    This is when the air is pushed up over the mountains forcing the cool air to heat (hot air rises), then you have the winds blowing this hot humid air which is terrible for people.

    The overall solution I feel is getting the temp down by ventilation (as in the cover lets hot air escape) or by moving the heat source (the new lamps) further back so that less heat is concentrated on the glass, or a bit of both.

    Let us know what happens

    Sheldon

  • 21 years ago

    Well I've moved the lights to the front of my terrarium (stil on left and right sides), and kept them a little farther away from the glass. This seems to have helped the heat issue, since the temp is now hovering around 82 degrees. We'll see if this stays the case, because I really want to keep these lights on my plants. I think they'll really benefit from the extra light.

  • 21 years ago

    I agree LG

    You dont want to throw them out, an increase of humidity needs an increase in light, thats how it works.
    People are not catching on that even though you have X amount of fluorecent wattage on your tank, it is not from a concentrated hotspot.
    Kinda like thinking if all the suns energy was focused on your house or on this country you'd all be charcoaled.
    But its spread which makes the amount of UV and energy acceptable.

    Your plants are gonna do good, Im sure of it

    Cheers

    Sheldon

  • 21 years ago

    Hey LG

    rco911 suggested that mabey I start a nursery like "Salt Lake Carnivores",lol
    If I do I hope you realise you gonna have to move to Utah, besides I need someone to design my terrariums that Ill be selling *Grin*

    Cheers bud

    Sheldon

  • 21 years ago

    Hahahaha, of course! I'll be your terrarium expert and design a whole line of state of the art terrariums that no one will be able to resist :p Complete with lighting, airpump, and reflective siding :D We'll be rich!

Sponsored
Miller Woodworks
Average rating: 5 out of 5 stars23 Reviews
Franklin County's Trusted Custom Cabinetry Solutions