Software
Houzz Logo Print
tjodine

Mercier Engineered Maple flooring

17 years ago

In September we had mercier engineered maple floors installed in our house, they where 3 1/4 premium maple in chocolate brown with a satin finish. The installation was great, the product looks great. The only issue I am having is trying to keep these floors clean. It is driving me crazy. I vacumn the floors and then damp mop with the approved mercier product but as soon as someone walks on the floor you can see the floor showing the marks of the footprints....even if they are wearing socks...if barefoot you can see that too....as well if you are wearing slippers or anything you can see those imprints as well. I looks dirty and dingy immediately. I had oak hardwood floor in my previous house that were sanded on site and finished with a water based eurothane. They never showed the marks as much as these floors, also we had prefinished (as our new ones were) oak floors installed in our kitchen of our last house in a darker look than the rest of the house (gunstock) and never had issue with seeing every single footprint. It is not enough to sweep the floor as I did before as regular maintenance in my old house...now I am required to vacumn, dry sweep and then use a damp product and scrub out the marks. Any suggestion? Ideas? Think it is the satin finish or the colour?? I would love to see if anyone else has these floors and are experiencing this issue. It is not a few marks on the floor...if we are walking around the whole floor ends up looking terrible!

Comments (10)

  • 17 years ago

    It's usually the cleaner causing this, some cleaners need to be towel dried before any foor traffic. Another issue is that cleaners should be used sparingly, not every week.... only when the floor is dirty so you don't get a build up.

  • 17 years ago

    Thanks for the input...what do you mean about being cautious about wet mopping with a cleaner? Also as an aside I have been using nothing but a barely damp microfibre cloth for the last few weeks with the same results as the cleaner as I never used any type of cleaner before. The floors are damp wiped only to get the marks off and then dried and I meticulously do this with clean, untreated material so as not to leave a residue. The finish itself is quite matte looking to begin with with little to no shine....could that be the issue?

  • 17 years ago

    I am reading this post with great interest. I am researching engineered wood flooring for our home, and came across this post. So, I looked up this company and sent them a few questions. I am happy with their quick and detailed responses. Have you tried contacting them?

    We are interested in doing a floating install (DIY) of whatever wood floor we decide on. We prefer the 3 1/4" width, and this company is one of the few we have found with a floatable 3 1/4" product. It is also sawn cut with a 5/32" top layer. Now, I am concerned about the finish! It's offered in semi gloss or satin. I assume the satin has less/lower sheen than semi gloss. I have heard that the lower the sheen the less scratches will be noticed. We are looking at a light color (like natural oak) which may not show foot prints as much as a darker color?
    I hope you can get in contact with the Mercier Co. and see if you can get this issue resolved. Can you post any pictures?

  • 17 years ago

    I haven't contacted Mercier yet as I was wanting some opinions before taking that step. I have no problems with the floor other than it shows everything and I mean everything. If you are looking at a lighter colour I doubt you would have the same issues but I would go with the semi gloss over the satin that we have. My last house we had a semi gloss gunstock oak that was great. I believe part of the problem with the floor is the low sheen as well. I took some pictures but they don't show the marks in the pictures! Good luck with your floors.

  • 17 years ago

    lots of problems occur when people over wet a floor. Damp mopping means using a urethane (hard rubber) mop head thorughly squeezed out. I've seen house keepers use a string mop. When I looked at complaints both parties say they use a damp mop. The problem is more in how you interpret wet or damp mopping. I don't think you need any cleaner on prefinsihed and if you had a bad area use a hardwood cleaner just in that spot. Beth Bath and Beyond sells Bona floor cleaner which is usually very well made.

  • 17 years ago

    Interesting....well I am not sure where my issue is coming from. It might just be the colour and finish of the floor. Over wetting the floor is not an issue as I am not doing that. As well I haven't used any cleaner in the last few weeks to see if that is the issue. It is not. I have the Mercier cleaner as well as the Bona to which I have stopped using both. My next step is to have my installer come in and take a look at the floors and see what they say.

  • 8 years ago
    Two days ago I had Mercier hickory flooring installed and am having the same problem with seeing footprints. I only wear socks or those soft footies. The flooring is pretty but the footprints make it look dirty. Have only used a dry mop. Not sure what to do. Can't imagine needing to dry mop this every day or more often.
  • 8 years ago
    Yesterday, I used Thomasville Wood Cleaner on my Mercier Hickory floors and at this point, I don't see any footprints.
  • 8 years ago
    last modified: 8 years ago

    In my opinion Mercier finishes are as good as it gets. The finishes look great and they emit low to no VOC. One of the downsides to a very clear finish with a high gloss level -- for Mercier that would be Semi Gloss or Satin gloss -- is you see footprints even from socked feet. Do you know what gloss level you have on your flooring?

    I don't have an answer to the sock feet but I'd strongly suggest you follow -- to the letter -- Mercier's maintenance (cleaning) instructions. See mercier-wood-flooring.com > All About Floors > Documentation > Maintenance Guide.

    Two reasons to do this, 1-they know best, and 2-if you do what they specifically say not to do (use wax, household detergent, concentrated wood cleaner, oil based soap, vinegar/water mix, no fabric softener when you launder the mop heads... they're very specific) you void the warranty, 35 or 10 years depending on the product.

    To get their finishes to meet the low to no VOC certifications they base the chemistry of their finishes on soybean oil, among other things (they don't make excessive use of plain old, traditional urethane for example). Their website explains this fairly well.

    To get their finishes perfectly clean, with no dull, translucent film afterwards, you have to follow their instructions exactly. Amazon sells their cleaning kits, and I think Bona is the closest third-party brand to what Mercier sells as their cleaning kits (50% micro fiber mop head, and cleaning fluid in a spray bottle).

    Hope this all helps.