Reset garage door motor signal

20 years ago

My wife has a remote built into her Land Rover Discovery. I think you call it a homelink. She divorced me and the house is mine now. How do I reset the signal in the motor so her car can't open the garage door? How do I change the key-pad number on the outside of the door so she can't use that either? I use a small remote that has a red light and a row of switches in side of it. The unit is a craftsman 1/2 hp. The number on the back of it is HBWO777. It also has one green button and one green LED on the back of it.

Thanks

Sort by:Oldest

Comments (2)

Don_
20 years ago
On the back of the motor unit near where all those white wires go you will find a button. Press and hold it for 6 seconds. At this point none of the remotes will work including the keypad. Now to program your remote, press and hold the button on the remote and then press and immediately release the button on the back of the motor unit. This will get your remote going. To program the keypad, press and immediately release the button on the back of the motor unit again and then walk over to the keypad and key in any 4 digit number and press enter. You will be set.
zenwarp
Original Author
20 years ago
Thank you so much :)
Related Professionals
Rocky Mount Accessory Dwelling Units · Mankato Accessory Dwelling Units · Jamestown Accessory Dwelling Units · Santa Rosa Accessory Dwelling Units · Port Saint Lucie Home Additions · Hagerstown Home Additions · Killeen Home Additions · New Haven Home Additions · Temecula Home Additions · Fairbanks Home Additions · Birmingham Carpenters · Fayetteville Carpenters · Bloomington Carpenters · Farmington Carpenters · Calgary Carpenters