Software
Houzz Logo Print
markmisky

Sealing subfloor from Tile board

17 years ago

Hi,

Five years ago I installed a tile floor in my bathroom. I did it per specs. I laid down mortar then put down either Hardyboard or some othe cement board. Then laid my ceramic tile, sealed it,set the toilet and all was well till last week.

I found water dripping in my crawlspace near the toilet. Apparently my toilet developed a small crack on the underside of the toilet. It slowly dripped into the grout then into the tile board and then to the sub floor.

I ripped out the floor to the subfloor and the tile board was wet about 1-2 feet in each direction and now have some dry rot to repair. I always thought that a tile floor in a bathroom would last forever.

I want to replace the floor but I want some kind of membrane between the subfloor and the tile. I thought about placing a shower membrane to the subfloor, then screw the cement board to it with no thinset, then lay tile. Home depot sells some roll on paint like membrane that is $125 and takes 2 days to coat and dry. Shower membrane is $30 and much tougher stuff.

What do you think? I see lots of threads about YOU MUST lay down thinset. Well, ok, but I also don't weant to rot my floor again either. So what do you do to protect the subfloor from moisture should this happen again?

Comments (2)