model number ?

Model 110 42924 200

Today I had it unplugged for hours, plugged it back in and I got it going for a load. Could not get it to start for a second load.

Spoke to a repairman and he thinks it is the digital board because there is no 'open door' message.

If it is the board then it would be about $300 for the part and I might as well look for new machines. Right?

Try the Diagnostic Tests on page 5 and the Troublshooting Guide on page 8
Whirlpool Kenmore 110.42924200 Tech Sheets

Sounds like this involves taking the cabinet off the washer. Units are stacked and I don't think I can physically do this by myself. Think I am in for a service call.

I re-read the info and did the diagnostic test. The only thing that happened is the .02 minute time flashed on and off. A very faint clicking noise could be heard once.

If the tech's suggestions that the open door message is not being received sounds reasonable. If a cycle finishes, and you try to start another cycle without opening the door, it will behave as you described. Check that the brown button, located in the door opening, is not sticking. I believe that is what indicates that the door has been open.

If is seems to be moving freely, another suggestion is check that all the electrical contacts/plugs inside the washer cabinet are firmly connected. After all this time, is it possible that something has shaken a bit loose. But that would involve unplugging the washer, un-mounting the dryer, and taking the washer top off - which is a pretty big job, and it may not be the actual problem.

Joe