Software
Houzz Logo Print
sheila99_gw

2cm granite dilemma -

16 years ago

I have read that the distance between the edge of the sink and the edge of the laminated overhang is usually 4 inches. I have a dilemma, if I use an 18" deep sink I will only have three inches, if I use a 17" deep sink then I will have 4 inches. Is 3 inches too thin for the distance? Which one is more important the extra room in the sink or the extra width in the stone? Is the stone more prone to break if it is only 3 inches?

Comments (2)

  • 16 years ago

    Sheila-

    The answer to your question will depend on 3 primary things -

    1. will you have one of those "tip out" drawers in front of the sink?
    if your answer is yes to this one - your sink will HAVE to be set farther
    back to accommodate the tip out drawer body shell.....

    2. what kind of space you will need behind the sink for your faucets and
    other accessories

    3. the thickness of the backsplash material that you're using behind the sink
    anything more than 2CM stone CAN have an influence on your set back
    from the front edge of the sink...

    For set backs - 4 inches is the "norm
    - but anywhere between 3 and 4 will be fine - the "fashion police"
    will not raid your home and "bust" you if you don't have a 4" set back.....

    just make sure that the stone is RODDED for the sink piece....

    hth

    kevin

  • 16 years ago

    azstoneconsulting: Thank you for your reply. You know, after I have all of this figured out, I would like to but together a "How to Guide" and post it on Garden Web for all those people who need help with this process. I think plenty of fabricators would benefit from this.

    1. Sink has no 'tip out' drawer.
    2. I have a total of 26 1/2" of cavity or empty space to work with, the cabinetry has been bumped out. Water faucet is Perrin and Rowe bridge faucet, escuthcheon is 2 3/8", I will need 5" for faucet (2 1/2 inch from the center of the faucet to the edge of the sink and 2 1/2 inches from the center of the faucet to the back splash).
    3. Backsplash is 2cm granite.
    4. I am concerned about the stone breaking if it is not wide enough!
    5. WHAT DOES 'RODDED' MEAN? How do I have them rod the stone for the sink area? You know, everytime I think I have it figured out .................... :(
    6.Who does the 'rodding'? Builder or granite fabricator?
    7.What is the 'rod' make of? Who sells it?
    I did purchase the 'sink' installation packet, thank you!