Software
Houzz Logo Print
jackre_gw

Toilet/drainage

18 years ago

Toilet/drainage question, hereÂs all the details

I have a split level home built in 1970, IÂm the lowest elevated house on my street and it poured last night. On the third level down, the lowest level with drained plumbing, I have a family room and a 2 car garage and in between those two are a half bath and a laundry room that are backed up against each other. 4 years and no problems.

Six months ago I completed a total remodel on the half bath including a toilet replacement (basic Koehler). Notes, The separation between the drain flange and the toilet was great enough to call for two wax rings and I had water pressure hammering until I opened the main supply valve a little more stopping that.

Just one week ago I finished a 3-4 week long remodel of the laundry room where I touched zero plumbing (other than tightening the valves on the spikets to stop some dripping).

As I was doing the first load of Landry in about three weeks, I noticed that the toilet bowl started bubbling up and slightly backing up a bit with laundry suds. Then I noticed some air bubbles while someone was in the shower upstairs. Both of these symptoms continued.

This weekend and yesterday as we did about 15-16 loads of laundry the bubbling and backing up continued. Last night I used that toilet and clogged it, it drained very slowly and over the course of about 4 hours I flushed maybe 20 times and plunged etcÂwithout any luck. I figured that IÂd wait till morning.

This morning my wife ran a load of laundry and it backed up and overflowed the toilet.

So here are my questions.

Does this sound like a typical clog?

If yes, can it be remedied by chemicals?

Or do I have to rent a snake?

I have a 25 foot flexible steel wall/wiring "fishing line" would this work?

Do these symptoms/series of events suggest any other possibilities?

Other input?

Thanks for your valuable time and aid!

Comments (7)

  • 18 years ago

    We have to assume from what you've said that you are on municipal sewer.
    If the main drain in the house gets plugged, the water will first back up into the lowest fixture in the house. It sounds like your toilet is the lowest fixture. If you have a place to push down the 25' fishing line, you could try it, but I think you are going to need something stronger than that. You could rent a small auger. If you get it cleared and it happens again, you should defintely investigate. Look at it this way, the largest opening in any of your fixtures is probably your toilet. The main sewer is larger than the toilet opening. So anything that will go through any of your fixtures should pass through the main sewer without plugging.
    If you get bubbling in the toilet when you are using nothing else in the house, then the problem could be with the city's sewer in the street.

  • 18 years ago

    I would not stick anything down a mainline except a full size snake meant for the large diameter drain, reason being a smaller snake can get turned around on itself in the big pipe and become immpossibly stuck.
    You could call the city first, if they have a property line cleanout they can see if the stoppage is downstream of there and it will be their responsibility.
    But most likely it's your problem and you will need to call a plumber/drain cleaner.

  • 18 years ago

    Liquid drain cleaners should not be poured into the toilet, they can splash back and only decome more dilluted. You can get hand operated toilet augers at Home Depot/Lowes/Menards which have rubber protection so they won't scratch the porcelain surface on the toilet. You should have cleanouts at the base of the waste stack in the lowest level, just above the floor line, try snaking here first. There should be another cleanout where the sewer leaves the structure, try here secondly. You can rent a mainline power auger, but theres a learning curve.

    Hope that helps,

    Dan Martyn

  • 18 years ago

    I'd like to add to Dan Martyns post that sometimes that learning curve hurts. Been there done that.

  • 18 years ago

    word of warning, if the clog is past the cleanout and your cleanout is LOWER than the first fixture that has standing water from teh backup, you will have a mess when you open it!

  • 18 years ago

    Well thanks for all of the replies; I really appreciate your time.

    Ok, so it seems like for the immediate time being, the first step in troubleshooting is that I should snake the drain. So I bought a 25 foot manual snake for 14 bucks and now I want to make sure that I am going to se it properly. (The directions are all but informative) This part of the house is on a slab so there is no immediate access point

    First, Do I have to pull the toilet? I really donÂt want to. Could O use the washer dryer drain as an access point if the toilet approach gets me nowhere?

    Second, if the toilet stays, should I use a towel or cardboard to help to not mark up the bowl?

    Do I want water in the bowl or should I turn off the valve and flush first?

    How far in do I push the snake before I start to spin it?

    How often do I flush during the process?

    Do I pull the snake out every so often to check it?

    There is only a small spring at the end, is this sufficient?

    Any other tips or tricks?

    Thank you again for your help!

  • 18 years ago

    first, you can try it without pulling the toilet. if the clog is after the washer drain it can be used.

    second, if you have an old water hose cut a 2 ft section of it and slide the snake thru it. this will act as a sleeve to keep from scratching the bowl. slide the hose down in the bowl until it goes back into the trap and then start runing the snake.

    water in the bowl, it is actually better is the bowl is real full of water so that you can instantly tell if you cleared the clog or not. if the bowl is not currently backing up, jus tkeep flushing it while you snake.

    you will feel it when you hit the clog, start twisting and keep pushing.

    as to the size of the snake, it will not clear out a large clog of grease/other solids. it will poke a hole thru it and MAYBE open it up enough that flowing water can force it open and clear. the only sure fire way is with a properly sized snake with teh proper head on it. you could run probably 50 snakes like you have down that drain at one time. think about it, that leave a LOT of room for stuff to hide!