Is this new construction or are you replacing an existing sink?

Is is a single or double sink?

If you are replacing a sink, is the sink your installing the same type as the one you took out? (single double etc)

A double sink in a remodel. I am not putting a disposal back in so im replacing all the pvc. Im using the kit that brings the drain water to the center of the sink. I hook the trap under the center drop with some up and down play. The wall drain comes from the right corner center of the cabinet.The first 6'' is galvanized then turns into plastic. My new pipe slides into it with a couple inches of play. The problem is when everything meets its an inch off at an angle. I would not like to use any flex type pipe for fear of slowing the waste water, but i will if there is no other solution. thanks again

the trap should be able to twist side to side enough to get you where you need to be. you may need to legthen/shorten a horizontal piece, but the it should not be that hard to do.

are you using glue together pipe or good old threaded PVC?

threaded pvc- twisting sise to side and legthen/shorten doesnt work its like a need a connector that has a 15 degree angle that isnt available. Part of the problem is the galvinized pipe that is to long into the cabinet.