I think they are great together! Will look timeless with beadboard....nice choice!

Shapes look great together. It could just be the photograph, but finish on knob looks a lot shinier to me than finish on pull.

I like them together, too.

Yup I like 'em to :) They work well together. That pull really does allow you to go either square or round, given that it has both elements in it's design. But, I do like the round one you've picked.

And yes, the project is probably eating your brain :P No one comes out unscathed from a kitchen remodel!

I like them! Do you have a square knob in mind?? I like square, so I'm anxious to see : )

Thanks for all of your encouragement. I think I'm going to go ahead and let KD install the hardware tomorrow, and if I totally hate it, I will take the knobs back and replace. Which won't be too hard, since he will have done the difficult part - placement.

The square knobs I considered were RH "Quincy." I actually would have like to use the Quincy knobs and pulls, but the corners seemed really sharp on the pulls and we have young-ish kids, so we thought better of it.

Here is a link that might be useful: Quincy Knob

Hi Gatorjaw -- we are looking at the same combo -- do you like the way they came out when installed? Did you use the small or large knobs, and where did you place them on the door? Would you mind posting pictures?

Thanks!

I like the two together. If you go with the square one I think that it will make the pull read more "craftsman." Right now it reads "totally unique"!

We did end up using them. I wasn't sure at first, but now I really do like them. Following is a photo from my kitchen, and then below is a link to another GWer's kitchen with Duluth knobs/pulls.

Here is a link that might be useful:

Sorry Brooklynreno, forgot to answer your question:
We used the larger knobs, and then a combo of 4 inch and 6 inch pulls. I did the larger pulls on my big drawers rather than two smaller ones. I am going to get the largest pull for my dishwasher handle.

HTH.