HELP PLEASE!!!

I am in process of completing the wiring into a Jandy Aqualink RS PDA controller (pool only) and would sincerely appreciate your wisdom and experience to confirm what I think is correct.

A. The breakers: Because I only have room for (2) double pole 30 amp breakers and (3) 220 volt units (heater, main pump, and booster pump) to wire, I have placed the:

1. main jandy 3/4 hp pool/filter pump on it's own 20 amp breaker and it's own filter pump relay

2. hayward 3/4 hp booster pump and jandy lite II heater on the same double-pole breaker also through the same aux1 relay

3. 15 amp single pole breaker for the fiberstars 6004 F.O. lights;

4. 15 amps single pole breaker for jandy control panel

5. 15 amp single pole breaker (not currently used)

B. The Aux 1 relay with the load 1 & 2 going to the booster pump and the line 1 & 2 to the breaker

C. The Speck Pump Badu Jetstream is power in established in another j-box on it's own breaker. But there is remote control to turn it on and off by the Jandy PDA with two wires into/from the Jandy control box. To do so I have wired the jandy-box's Aux 2 relay as line 1 Badu to the jandy and Aux 2 load 1 from the jandy to the badu's control j-box.

D. Then the Fiberstars 6004 lights on Aux 3 but placing the control brown wire from the fiberstars unit on relay 4 line (1?).

E. Also have a solar system to be installed late next week into the Jandy; but not sure what connection or breaker/relay it will require other than the solar JVA and Solar sensor connection into the low voltage side of the jandy control box.

F. Dip switch settings 1-4 on 5-8 off.

Your comments and thoughts . . . please.