I would contact the manufacture outfit to get the proper replacement parts and if you dont feel confident about d.i.y, seek out a reputable handyman in your area.

Most all steel and fiberglass door manufacturers use "commodity" inserts for full lite, half lite, 9 lite, 15 lite, etc glass inserts. They don't make that part (plastic frame with glass inside) but instead cut the hole in the door blank and insert the glass made by specialty manufacturers that service the door making industry. They are referred to as commodity inserts because usually inserts from different companies are interchangeable.

They are sold with both inside/outside trim AND the glass as mulchmamma said, and you have to double-check the sizes. My company was just able to sell (10) 9 lite (same size as 1/2 lite)sets to a company on the other side of the country WITHOUT the glass. They loved this of course because it saved them a fortune on shipping (weight) and they got to re-use their perfectly good glass anyway.

You didn't say what your window was. For example the units i spoke of were 23 3/4"W x 37 3/4"H, measured to the outside dimensions.

I thought i'd throw this in as i got a few email questions:
Usually a 2/6 door will have a smaller width of 21 3/4", and the larger doors will USUALLY be 23 3/4".

If your measurement is within a 1/2" or so it will work.
Ed

Could You tell me the name of the companies or where can I purchase the trim?

I would also like to know the name of the companies. If I take it in to Home D do they do this type of repair....ie replace the trim and or glass? Anyone able to estimate the expected cost?

Thanks,

Alpharetta, Ga.

More than likely would need the manufacturer of the door as they are all slightly different. None are interchangeable from what I know. It is also the entire frame that holds the glass in place.

I am looking to replace a wrapped and cracked plastic frame on my front entry full lite glass door. I contracted Stanleydoorproducts.com since my door is a Stanley branded door. I will be sending measurements and photos to see if I can get a replacement.

I have the same problem. What is the part number to replace the plastic trim?

I found a company online called DIY Doorstore. They had the frame in stock and shipped it out right away. I had it in a few days. They had it for both my front door and the two side windows.

Noreen, I got the exact trim I needed thanks to your information from Pease door.

Thank you!!