Software
Houzz Logo Print
kapustak8

Size matters...for a microwave shelf

18 years ago

We're finalizing the plans for kitchen cabinets, and our cabinet maker has suggested a 21 inch wide shelf for the microwave. This seemed kind of small, so I hied myself over to Best Buy with my tape measure and found that 21 inches rules out a lot of MW's. I'm thinking 24 inches would give more room for air flow, since all of the MW's I looked at had vents on the side. I want to have a shelf that will accommodate future microwaves, as well, since I don't expect this appliance to last 20 years, or 10 years, for that matter. So all of you GW posters out there...whip out your tape measures and give me some feedback on the size of your MW shelf...please! Width and depth would be most appreciated.

Comments (8)

  • 18 years ago

    Most of your "standard" large capacity MWs will be 24" models. That's why I never put in anything less than a 27" MW shelf in a design unless the customer specifically requests somthing smaller and is just a single or couple. And even those folks want a full sized MW to be able to heat up full sized casseroles.

  • 18 years ago

    You didn't mention the other dimentions of your shelf(upper or lower cabinet?), so just in case, I thought I'd mention that you might want to make sure you also have AT LEAST 17 inches of depth to save you the trouble we had trying to find a shallow depth microwave.

  • 18 years ago

    My cabinet is 22" wide. I don't forsee ever needing a super huge micro. There are plenty of options out there to fit the space.

    A follow-up to crashboombang's point about the depth... the plug for the 'wave will eat up another couple of inches of precious depth. If that's a concern, plan to have the plug in a cabinet above or below and snake the cord through to the adjacent cabinet.

  • 18 years ago

    Thanks for the quick replies! This is a new build, so we have no existing shelf, and we will need a new MW for the new house as the old house has an OTR MW which will stay put. Plans are for an open shelf in the upper cabs with a dedicated plug located there. It's just me and DH, so we really only need a mid-size unit, maybe 1.0-1.2 cu. ft. Still, a GE Spacesaver, for example, was almost 24 inches wide, though not very deep, while the Panasonic Inverter was just a shade under 22 inches, but deeper.
    Any others out there with shelf measurements to offer would be much appreciated!

  • 18 years ago

    I had originally planned to put the 24" w x 12" d GE Spacesaver in our new house. However, once DH started looking at MWs, he decided he wanted one that had convection. That was both wider and deeper. So, I was glad I had the MW on a countertop that was 33" w & 24" deep. (We'd raised the left base cabinet holding the single oven to 42" h).

    Anne

  • 18 years ago

    Ours is a Kitchen Aid built in "24-inch" apparently meaning it fits in a 24" cabinet - not that its actual body dimension is 24".

  • 18 years ago

    we have ours in an upper corner cabinet, so the depth wasn't an issue at all. we thought it was a great use of the space, since those cabinets tend to go back so far that stuff just gets lost back there anyway.

Sponsored
J.Holderby - Renovations
Average rating: 5 out of 5 stars4 Reviews
Franklin County's Leading General Contractors - 2X Best of Houzz!