I used 10" pulls for my 22" drawers and 8" for my 18" drawers.

bump

We have IKEA Nexus yellow-brown cabinets with mostly drawers. We used the IKEA Spann handle, which is about 9" long. I considered the long bars that cover the whole drawer-front, but that seemed more industrial than what I wanted, and seemed a bit trendy to me. The 9" length is good. It is wide enough for the wider drawers (one handle mounted in the center) but not so wide that it overwhelms the smaller drawers.

bump

bump bump

I had read on this forum that the rough rule of thumb is 1/3 the width of your drawer. That's what we did, though it was never exactly 1/3, but close enough. Also, we did a cardboard cutout of each size our handle came in, and held them up to various drawers and cabinets to make sure it looked right. The cardboard cutouts took about 2 minutes to make (used a scrap of cardboard from the boxes the cabinets came in), and was a great tool for when we were undecided between two sizes.

What size handles? The drawer sizes are 30 inches 24 inches and i8 inches inches.

If you are getting those handles that come in practically all lengths possible, buy a batch of handles of the sizes you like, install a handle onto those drawers you are certain of, and see after a week or two what size you want on the remaining drawers. Return the remaining handles to Ikea a month or two later.

Post a drawing showing the surroundings. If the sizes (18", 24", 30") are all mixed together or not, this will change the view onto the one or two you are uncertain about.

A lot depends.

So far you haven't said much about the actual handles.

ne wthread

Here is a link that might be useful: Inarticulate new thread

bump