Software
Houzz Logo Print
hzdeleted_19709514

External Exhaust Vent Cover - Need to Adjust/Replace

11 years ago
last modified: 11 years ago

Hope this is a good forum for this, if you have a recommendation for a better forum let me know.

Our kitchen cooking vents outside, and has an external cover similar to a dryer vent but it isn't sealing well. I didn't recognize how bad it was until the recent cold temps and now am trying to address it.

The vent tubing is 5", which is not a size they carry at Lowes/Home Depot. I did try to remove the old one to see if I could adjust it and discovered something alarming/concerning. When it was originally installed, the builder screwed the vent cover's tube INTO the vent that goes into the house. So, when I open the vent cover from the outside and look down the tubing, i see three screws protruding into the tubing from the outside and in an area that I can't get to without ripping the siding and potentially flooring apart because it's relatively deep (like 6") into the tubing. Why they would do that I have no idea, but what I do know is that I can't budge pulling the external vent cover off the tubing to replace it.

I'm contemplating my options and am considering things like using a Dremel or another similar tool to cut the portion of the screws I can get to and then drying to poke them out of the tubing, though the 5" diameter doesn't give me a lot of room to work with. I could potentially try to lift out the cabinets, but that seems pretty excessive.

Another option I was considering was to install some sort of magical flow regulator in the tubing that I have access to in the house, which would basically allow external flow when the fan was running, but would stop airflow coming in when the fan wasn't running. This feels like a good option all things considered, but I'm not sure if something like that exists or if there are guides for installing it.

I can post pictures if what I'm explaining isn't coming across well, and thanks in advance for your help!

Comments (9)

  • 11 years ago
    Here is a picture looking through the external vent cover. I unscrewed the exterior cover, but the tubing will not budge. Thinking at least one of those screws is securing it to something inside the frame of the house.
  • 11 years ago

    Have you considered replacing the end cap with a new style?


  • 11 years ago

    Yeah, I would love to do that. Just don't know how I get the old one off!

  • 11 years ago

    Sorry...I was misled since you mentioned that you removed the exterior cover. Maybe an image from a distance may reveal some other clue to options.

  • 7 years ago

    I've run into a similar issue with the screws in the tubing. Just curious if you were able to resolve this and how you got rid of the screws if so.


    Thanks.

  • 7 years ago

    I think the OP probably fixed this 4 years ago! However, for anyone else in this situation, running a 4" pipe inside the 5" pipe might work and might also be more compatible with current hoods and vent covers.

  • 7 years ago

    Actually I never solved the problem!!

  • 7 years ago

    Well, now's your chance! ;)

  • 7 years ago

    I was finally able to resolve the issue (with some help). After cutting the existing vent cover and the mesh screen covering the tubing to get easy access I tried a few different things but couldn't do anything useful with the screws. I got help from a handyman and he just used a pry bar to pull the crimped end of the ductwork off of the 3 screws. Took him about a minute, not sure why I didn't think of that.


    Anyways then we were able to pull out the existing vent cap and replace it with the new one. My ductwork had a 6 inch diameter though, so it was easier than what the OP has to deal with.