This problem is typically caused by a partially clogged/obstructed or malfunctioning diverter valve that isn't fully shifting into drain position. Part of the pump stream during drain is going toward the recirculation hose/port (instead of all the flow going out the drain hose). The recirculation stream hits the rim of the basket spinning at high speed and sprays around under the top deck ... leaking from under the lid and down to the floor, and sometimes water will come out from the seam between the metal cabinet and plastic top deck.

As you probably know, the recirculation port is at top of the tub under the tub cover at approx the 1:00 position. You can observe during drain (immediately after wash or rinse, before the lid locks for spin) whether any water flow is coming from there .. should not be any. Or, you can observe the situation during spin by raising the top deck (with the lid remaining closed/locked). Pry out the two lid bumpers near the front corners, remove the screws beneath to raise the top.

The diverter valve is mounted to the bottom of the tub near the pump. Has three hoses connected to it (a short U-shaped hose from the pump sump, the drain hose, and the recirculation hose up side of the tub). Could be lint accumulation or a small object such as a hairpin or dime obstructing the diverter from fully shifting to drain position.

Hey dadoes, I have read about a diagnostic mode, how do I get to this. Also I hear you have a repair manual for this machine as well, is it possible to see this??

Thanks again for your help as to have someone come look is very expensive.

Dadoes, I was able to locate the converter valve and did find some debris in the u shaped hose. I mistakenly unplugged the power from the diverter. Is there a way to know which way this goes back? Thanks again for the help.

Dadoes, the debris was a toothpick that was wedged inside the diverter. I was able to pull the toothpick free, with some work. The diverter looked clear on that port. But you suggest removing the entire diverter to ensure its clear?

good to know about the power. I wanted to make sure that the wires would not have to be plug into a certain plug. Some items are like that and can cause issues or short out if plugged in wrong. Thanks again for all your help with this.

Dadoes, I pulled out the diverter and the other ports were clean. I put it all back together and it ran through fine. Thank you for all your help with this!!!!